TelePresence and Video Infrastructure

strange problem......2650xm router with a NM-HDV module and a VWIC MFT E1 module connected to PSTN ISDN-30 PRI. It's worked ok for years but now gets slip secs and error secs clocking up.We have replaced the NM-HDV and the VWIC twice and now the rout...

I use a Cisco 1760 Router with 12.2(11)T IOS and I try to configure the t.37 protocol. Olso, I use a linux smtp server for a fax mail server and a fax machine connected in a FXS port. I use the Cisco Configuring documentation in the configuration pro...

I had a problem configuring IP Plus ver S26CP-13313 and NM-HD-2V with VIC2-4FXO for Cisco 2620XM router on the configuration tool. Previously I used S26CP-12208ZJ and it is no more available on the configuration tool. What should I use?

Hi,Does anybody know if vt advantage works with a 7985?Thanks

Why i cant use the IP Communicator with VT Advantage?

hello :I need some IVR scripts for my AS5350 but I cannot find them on cisco web site.anybody can tell me where and what files, thank you

I have a QoS question.How do you prioritize voice traffic?In my environment I have multiple VLANs and a switching fabric. I would like to start using IP telephony with IP phones ofcourse. Do I need to add a new VLAN? Based on what do I need to priotr...

Hi Can i use cisco vg224 gateway in a scenario like -cisco ISR+CCM express -->WAN LINK --> cisco ISR -> VG224 gateway --> analog phones.If this scenario is good then, can i do call transfer and forwarding with analog phones with any extensions digita...

Do Cisco VT Advantage endpoints support Far End Camera Control of remote H.323 endpoints (or as a navigation mechanism for a video-enabled auto attendant on an MCU)?

Are there any fundamental differences between the Cisco IP/VC MCUs and the RadVision equivalents, e.g. Cisco IP/VC 3511 and RadVision viaIP 100?Will the RadVision JVS scheduling software operate with the Cisco IP/VC MCUs?

I’m trying to dial my IPVC IVR from a IP phone. I have set up H.225 trunk in CCM and a route pattern to point to that trunk. I created a static e.164 address on the gatekeeper to point to the IVR. When I dial the IVR from a phone “IVR Application” sh...

I'm designing a new solution for a customer where i want to ensure there is redundancy for my "Directory Gatekeepers". What methods of redundancy works best for Directory Gatekeeper? Is HSRP good or Alternate Gatekeeper better? Any suggestions would ...

Hi all (1) Pls I need someone to explain port forwarding i.e. forwarding a udp port to a specific host .Can Natting be used? (2)Secondly what is SIP NAT traversal? What is the effect of turning it off? (3)I have natting configured on my router if I i...

I have a Point-to-Point WAN using T1s. I have at the host location a Northstar connected to a 3640 via a T1 (NM-HD), and the remote sites 1751 with E&M trunks to a Northstar. All of this works fine, we added a new site with a Nortel BMC 50. I can ...

Is it possible to configure an H.323 endpoint/MCU to dial out to SCCP endpoints (e.g. Tandberg Skinny compatible endpoints, Cisco VTA and the Cisco 7895 video phone)?I can set up a gatekeeper-controlled trunk (and associated route pattern) to allow S...