Dear All,
Just one clarification, we need to add an additional display for the presentation.
Now in the existing setup we have only one display for the presentation in the bottom centre and we need to mount an additional display on the top for pr...
Hi,
Anyone know which part of CMS configuration is responsible for domain part of the URI.
We had CMS configured to be on domain A now we changed all configuration to be on domain B. Yet the URI is still showing as domain A
ALPTSCMS01A> xmppEnabled ...
SX20 device does not allow upgrading from version TC7.1.4 to TC7.x.x
Could you tell me if TC7.2.x versions are available? orCould you tell me how I can update this device?
The current version of the equipment is TC7.1.4.
Thanks
! Regards!
Hi
I am installing mx300 at my client location.
But it's touch panel (10) is showing Downloading software in maintance mode.
I have done factory reset twice. But still its showing same message.
Regards.
Amol
Hi All,
I have an issue with Cisco SX10 Video Output to Multiple Displays,
we have connected 10 displays through HDMI Senders / Receivers,
when we connect SX10 Output to HDMI Sender, its not displaying video,
if we connect single display its working...
Hi everyone, i made a trunkk between CUCM and VCS, calls from VCS registered endpoints are OK, calls from CUCM registered endpoints are not workingMX200 registered on VCS, EX60 registered on VCS, TANDBERG 1700 registered on VCS and DX80 registered on...
VCS controll version is 8.9.2 , TMS version is 15.4.
#174 - TMS Provisioning Extension services communication failure - The VCS is unable to communicate with the TMS Provisioning Extension services. Phone book service failures can also occur if TMS d...
Hi Guys,
Has anyone integrated Polycom VVX 301 Phones with CME. Specification on Polcom website highlights that VVX 301 supports SIP Protocol. Support Documents from Polycom highlights the procedure to add their SIP Phones to CUCM but nothing for CME...
Any ideas please.
CMS 2.2.5 version X-Series appliance.
Getting the following XMPP Info in logs
XMPP component connection disconnected due to failure reason: "authentication failure"
XMPP handshake failed for reason 7
XMPP thread state failure 1
??...
Hi
When scheduling a CMR event, we are looking to find out if there's a way to invite TMS machines. So rather than dialing the SIP number manually, the endpoint would have the event appear in its calendar, and the user can just click the join button...
Hi there,
Apologies if this is a bit of a numpty questions but I am finding the CMS documentation a little vague and I'm new to CMS!
Just a quick question really that if anyone has some steps for adding a license to an up-and-running CMS server?
I ...
Hi Friends,
I am doing a RA VPN configuration.
MAC -inbuilt VPN client -> ASA -> TACACS+authentication using AD using CISCO ISE ( this is my required config)
MAC-inbuilt VPN client -> ASA -> Radius authentication using LDAP ( current config)
MSCH...
Hello,
is there a way to disable showing the name or number of remote participants on SX80 with CE8.x (See Screenshot below)?
We use SX80 for Webcasts and there it disturbs a bit if the name or number of remote participant is seen.System is register...
