Is there a way to disable SecureBoot Support on C220 M5?Need to install ESXi 6.5 and I'm getting an error "Invalid Signature detected. Check Secure Boot Policy in Setup"
Forum Posts
Hello, during the installation of the Hyperflex cluster I had created iSCSI interfaces for this kind of traffic.But I am dealing with these errors now. host-eth-10 and vif-1298 are tides to the iSCSI interface.How can I shut down or disable this prep...
Hi all,We are deploying cisco hyperflex edge cluster of 2-node.After providing all the required details in the hx installer wizard, when we start the validation process, there is an error in the deployment validation stage. It says "Errno 113 no rout...
I have a Cisco HyperFlex with 9 TB of disk space. I created 10 VMs and had those VMs running for about a week, after that, I deleted all the VMs(Delete from Disk) on the vSphere web client, but I am not able to get my space back and it disappeared. l...
When executing the command ucse sub 1/0 status, does not report any information. The blade is working fine otherwise, statistics works through the isr 4351. ISR4k#show version | inc RELCisco IOS Software [Fuji], ISR Software (X86_64_LINUX_IOSD-UNIV...
Good morning! I am fairly new to Cisco UCS, so any help you can provide would be much appreciated. I have some B200 M5 blades here where I am trying to map the diagnostics image in order to test the blades for a customer. After successfully mapping ...
Hi Freinds Kindly , Find Attachments How to fix this issue , pls step by step Thanks Ibrahim
Hello Guys Pls Find Many Attachments I m trying to install ESXi 7.0 but no Disks Detected eventhough the Disks online and VG , created with RAID 0 Kindly help me to solve this issue thanks
Hi, I am facing an issue on the Port VLAN Count Optimisation regarding issues on one of our infrastructures. This infrastructure uses multiple uplinks for different physical LANs (internal and external exposition are on two different phy networks for...
Hi, I have a customer that implemented DJL2 for a temporary project and DJL2 was setup correctly by placing the VLANs (via lan uplink mgr) on the appropriate uplinks. The environment is 10 chassis 4.0(4b). Currently there is only one port channel th...
Hi. we need some help understanding why HX cluster is completely shutdown when we have a failure. Let's say we have a 4 node HX cluster, with RF2. If we remove 2 disks from different nodes, the Cluster is shutdown.We understand that RF2 means 2 copie...
My UCS server suddently cannot access the ESXi. After reboot, that showed the below screen. Any idea?
Resolved! CIMC Upgrade for CSP-2100-X2
Hello! According to the release notes of my target CSP version release I need to go to 4.0(4d). I am currently on 3.0(3a) according to the logon splashscreen, and in the Firmware management section.I think the CIMC link provided bellow works for my C...
Hi, We are having pair of Fabric-Interconnect 9296 On the blades, there ESXi installed, with VMs on it Yesterday we had some network issues, and after 2 hours of T-Shoot, we get in to a point that we saw that there was a VM installed on some ESXi t...
I've got some C220-M5's running 4.0(4c) firmware with a fresh install of vSphere 6.5U2 (Cisco custom). Also using VIC 1457. I'd like to use the 2 onboard 10Gbase-T ports for management traffic on the ESX hosts. The problem is that only the 4 MLOM (VI...
