Unified Computing System Discussions

Hi I have a UCS-C220-M3SBE3 with a fail hard drive the HDD part number is A03-D500GC3 and this HDD have 500G capacity, but this part number is end of sale... the replace part number for this HDD is UCS-HD1T7K12G and this HDD have a 1T of capacity. Ca...

Hello, I am in the process of switching from VMware Horizon View to XenDesktop.  I am attempting to convert a Cisco ucsc-c240-m3s from vsphere to XenServer.  I started trying to install version 7.1 of Xenserver, now I am playing with 7.2.  On the UCS...

Hi, I have a attached a screen shot with details showing the firmware version of fabric interconnect, ucs manager, vic adapters , etc. I have 1 server in the chassi. I have configured 1 server port, and several uplink ports which are connected to la...

Hi. We have taken over responsibility for managing a 2 domain Cisco UCS environment and wish to centralize some management and all monitoring via Cisco UCS Central. It appears that the original 'Initial bundled 5 Domain License' may no longer be ava...

Hi, I've found a few UCSC-C240-M3 with no drives and internal RAID controllers and we are going to use them for our test environment. After reading the data sheets we knew that UCSC-C240-M3 supports up to 12 SATA drives as a single logic volume but w...

I would like to enable CDP on UCSC servers so that it will show up in 'show cdp neighbor' in the TOR switch. By default, I don't see CDP is enabled. Would you let me know how to enable CDP on the UCSC server ThanksThanh

Hi All, 10.38.236.194 has been configured on eth0 of the Cisco VIRL VM, however it is still not reachable from Nexpose for security scanning. Nexpose is on the same VM ESXi host as the Cisco VIRL VM, so no networking involved. Packets should leave ...

Hi~ How can I disable CDP on Ethernet Uplink Port of UCS FabricInterconnect? I can't find where I can disable CDP in UCS Manager and NXOS mode. Please Help me.

Hi~ Is it possible that user account's password of UCS Manager is expired? Thank you.

I'm looking at using SCOM monitoring to monitor and alert on UCS Fabric Interconnect performance however I have not found any pertinent information indicating if this is doable in SCOM or not. Any guidance on this is greatly appreciated.