Unified Computing System Discussions

I've got a C220M3 which is reporting four DIMM slots as Disabled (or Ignored/Disabled depending on where you look) I've moved DIMMs around, and the fault stays with the same slots. As the memory controllers nowadays are on the CPU, I assume the CPU ...

I am running into issues importing a logical config into UCS PE.  I've tried the newest release as well as well as 2.2(5a).  I was able to successfully import the hardware config from my FIs. When I try to import the logical config backup, I get this...

Hi,can the cisco ucs support snmp on it/s virtual-ip, we have sucessfull snmp walks to the individual physical ips of both the FIs, but not the vip.

I have a C220M3 running the latest (2.0(13f)) firmware. The CIMC is showing the FlexFlash as being Degraded. When I look at the FlexFlash via the CLI, I see: /chassis/flexflash # show physical-drive Physical Drive  Slot    Controller   Role         ...

Hi, After migrating data from an old SAN to a new one, we need to disconnect the old SAN from the fabric interconnects and make sure the port licences move to the interfaces connected to the new SAN. The current FC uplinks are as follows on both FIs...

Hi, We have two Cisco UCS C-series servers (C210 M2) with VMWare Esxi 4.1.0 and we need to configure them for snmp monitoring using Cisco Prime. How do we do that. Please note that we do not have Cisco UCS Manager. We have CIMC though. We use VMWare ...

Just wondering if anyone can shed some light on the behaviour of authentication the Fabric Interconnect 6200 currently running software 2.2 5(d). I've just had to RMA a unit and found with pairing the new unit to the cluster, we have to set the authe...

Hello Team, I am using a pair of 6248 UP interconnect with 4 links discovery architecture & 4 uplinks for ethernet (No FC, only ISCSI).Rest 44 are server ports. Questions is maximum chassis i can connect? i belive 11. correct me if i am worng. If i w...