Unified Computing System Discussions

I had updated our UCSM from 2.2.3e to 3.1.1h successfully a couple of weeks ago and then felt comfortable enough with proceeding with the Server Firmware updates after updating our DR/Test environment successfully. The update failed and now I'm stuck...

loader> boot tftp://172.16.1.100/n7000-s2-kickstart.6.2.6a.bin Address: 172.16.1.2Netmask: 255.255.255.0Server: 172.16.1.100Gateway: 0.0.0.0 Filesystem type is tftp, using whole diskBooting: /n7000-s2-kickstart.6.2.6a.bin console=ttyS0,9600n8nn quiet...

Hi Experts, I have couple of UCSC-C220-M4S that will be directly connected to Fabric Interconnect without going through a FEX. The Fabric Interconnect will be connected to Nexus 5K. I know how to set up FI cluster and configure uplink ports and serve...

Hi, Would someone know where can I download MIBS for Cisco Integrated Management Controller (Cisco IMC) [UCS C220 M4S] Firmware Version 2.0 (10b). Thank you.

Hi, Would someone know where can I download MIBS for Cisco Integrated Management Controller (Cisco IMC) [UCS C220 M4S] Firmware Version 2.0 (10b). Thank you.

Can I replace a b200 blade with am older CPU type with anew B200 with a Haswell chipset by just adding the new to the same slot as the old. We are using boot to SAN

Dear Friends, I will implement a new UCS project and I have this Part Number C1UCS-OPT-OUT for each Blade Server. I take a look in the Cisco site but I didn't find any reference to it. If someone could explain me what is this Part Number is for I w...

Hello,We have Rack server with two VIC 1225, managed by UCSM(single wire  management),   Single Wire Management  of rack serveer only supports single NIC.  Is there anyway to use second NIC as redundancy , in case one VIC 1225 fail?Thanks in advance ...

UCS Manager Upgrade from 2.2(5b) to 3.1I have below detailsI.Cisco UCS1.     Cisco UCS 5108 / N20-C65084 x Cisco UCS B-Series Blade ServersCisco UCS B200 M3 / UCSB-B200-M3Cisco UCS B200 M3 / UCSB-B200-M3Cisco UCS B200 M4 / UCSB-B200-M4Cisco UCS B200 ...

Hi Experts, Please help me to understand VSAN deployment between FI and Nexus 5K over Traditional FC. Should i use 2 different VSAN between FI and N5K or one VSAN on both side would be fine. if there is any reference doc please send me link. i would ...

I have been trying to find documentation to find out if the UCS C460M4 is supported with CWMS 2.5.   If the answer is yes, does anyone have a sample configuration or where I can find one.   Thanks

Hi, today, i saw that my vmware tools are not running and also at startup are not able to start. I updated ucscenteral to 1.5.1, but the issue still remain. How am i able to update the tools or repair the installation of the tools? Thanks Frank