We need to temporarily shut down one of the sites of our HXDP 5.0(2e) based stretch cluster (with RF 2+2). The cluster has plenty of compute capacity (all VMs can easily run on one site). I am hoping it is as easy as:Confirm in HX Connect that cluste...
Hi all.
Very simple question, I am getting mixed messages about the above? I can't see any where from the GUI or CLI commands to replace the HX Connect self-signed certificate with a customer signed one? Has anyone done it, or knows if it can be don...
We had similar issues Reported.We had Fabric A and Fabric B which has MDs 9710 on each side. FI-A is connected A side MDS and Fi-B is connected B Side MDs.On A side we had 5 members of Port channel out of 6 Ports went offline. This has caused due to ...
Hi All,is there a way to simulate the state link down of one Vhba in my service profile?In my environment I can't remove the FC uplink cause more then one service profile are pinned in port.Thanks!
Hello everybody, Do you have a method to remove weak ciphers for SSH protocol in UCS fabric interconnector 6324 mini, i have just the option to enable or disable SSH but not to configure ciphers, macs, e curves, or some documentation that should c...
How to Migrate service profile from UCS 6200 to 6400/6500 FI.is there a script we can migrate the service profile, pools, policies to new FI. this new FI will run parallelly to the existing FI.we want to migrate one blade at a time.
I got b200M3 profile installed with esxi 6.7. I want to unassgen the profile to b200M4. Are there any issues with this? If it boots up I can do cleanup of drivers or update them while i upgrade to 7.0. Idea is save time and not recreate new service ...
Hi alli am planning to upgrade UCS Infra 4.1---4.1.3h----4.2.3once i am upgraded infra through above path can i upgrade b and C host firmwares direct without going to intermediate ?
We have an issue in 1 of our backup server which is rack mount server UCS C240 M4SX integrated to UCSM managed through UCS Central, is not booting up.
The KVM IP is also not pinging hence we are unable to launch KVM. Physically the server is up but f...
Hello,
I have a UCS 6200 that is in a bad configuration state. It needs to be wiped.Both FI's boot as secondary and don't permit login.I'd like to just wipe the configuration but all of the documentation I've found requires access to nxos.Is there a...
Hi,we need to chage the IP of UCS Central due to some conflict, but the UCS Manager is regsiterd in UCS Central using IP, how can we register with UCS Central FQDN without unregistering it?
Hello,We have a number of Cisco UCS M4s which we no longer have hardware support for, however there are some legacy applciations running on them, so we need to keep them running for the foreseeable future. We are currently running 3.2(3c) on the Infr...
