Unified Computing System Discussions

Engage with peers and experts on UCS and HyperFlex topics.
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Hi all,I ordered rackmount server(C210 M1) with Broadcom NetXtreme II 57711 which I would like to connect to Cisco UCS 6120 in switching mode, but I can't make it working. Broadcom has 2 slots for SFP/SFP+ so I inserted Cisco SFP 10GBase-SR into it. ...

Part of Intel's revision from the 5500 to 5600 series processor was support for maintaining memory speed at 1333 MHz (for the processors that support it) with two DIMMs per channel. Will a B200 M2 with x56xx processors run memory at 1333 MHz with two...

Since Windows 2008 is a couple years old, it doesn't have a built in raid controller driver for UCS C200M1 servers.  Windows did not discover the RAID controller in the server, and none of the drivers I've downloaded from Cisco appear to be correct. ...

Jason Aarons by Frequent Contributor
  • 1 replies
  • 0 Helpful votes

Hi,If I want to power down one UCS B-Series Chassis, do i need to put the blades on standby via the "power button"?I noticed there's a power button on each blades and it's orange/amber when there's no service profile association.However, pressing on ...