I have a SPA 2102 phone adapter with router. I receive no dial tone from my phone, and all cables are connected properly. I have powered the adapter down and waited 30 seconds before turning it back on, and I still receive no dial tone. ...
I need some help with configuring Dynamic PAT (I think).Here is my setup:-Cisco UC520 runing latest software pack.-Configuration done using CCA-Block of 5 Public IP addresses-2 Internal webservers on port 80-UC500 Internal IP 192.168.10.1-UC500 Exter...
Dear support,i have already purchased a call manager business edition 6000 version 9 without UCSS. how can i order now the UCSS on CCW? what's the top level SKU?Thanks
Hello,I have an intermitant issue with one of our UC320W's running 2.3.2(6) firmware. The customers VOIP SIP trunk becomes unregistered for periods of time, stopping incoming and outgoing calls. Once unregistered it takes quite a while to rergister...
Dear, I'm trying to set up a link E1 ISDN voice in my uc560. I contacted Telecom and she said to did not need to define the "Switch Type" (as: Net5 5ASS, 4ASS....) they use a modem to convert the signal that comes from the fiber to rj45. Currently, m...
Hi, I have one UC520 and one UC540 with a sip trunk between them. On UC520 I have a SPA508G with a 500S addon. I would like to setup on 500S some buttons to monitor lines on UC540. Is it possible ?Regards
My Company use BE3000+SPA8800 , and our customers(use Microsoft Lync Phone ) can not dial extension number from PSTN( it is ok to connect to AA but when type extension number, there is no response). It seems that auto-attendant device is not sensi...
What is the secret to MOH sounding good on the cell phone? We have tried the built-in MOH file, tried uploading an MP3 via OfficeManager, and plugged in Muzack via the external port. All sounds good internally, all sound terrible on a cell phone. I h...
We deployed a BE3000 about a year and a half ago. Had a fair share of problems, but thankfully got most sorted out after a while.One problem that has persisted is what could be described as a 'phantom dialtone'. Most often experienced first thing in ...
Can a page be sent to all the idle phones at a site? Ideally, the customer would like to use phones to broadcast a page throughout a facility. What are the options on a BE3K?*Partner Question*
I have a question regarding the delay from dialing a number till the dialed phone starts ringing. If i dial through the analog phone connected to my SPA3102 the dialed phone rings 3 sends later in comparison with dialing from phone when its directly ...
I have a device connected to a SPA112 which initiates a call to our operator. When the operator ends the call the device goes silent for a few seconds then gives the off hook howler tone. As there is no handset to this device, the only way to stop th...
Model : UC520IOS version : 12.4(20)T4CME : 7.0What version of Cisco IP Communicator supports for the UC520 with CME7.0?Release Notes of IP Communicator is not included CME7.0 in Supported Releases.http://www.cisco.com/en/US/products/sw/voicesw/ps5475...
I have two SPA414G IP Phones with screen displaying “S.O.S. – Phone In Recovery Mode”I did follow the procedure to recover SPA514G without any success.I did notice on the Configuration Upgrade that Software Version is 7.5.1tec. (see attached picture)...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: