We recently installed a BE6K with the VMWare version 5.0.0, 623860. During our configuration testing we realized that the VMWare was not restarting the virtual machines automatically. They were configured originally to start within 2 minutes of the...
Hello,I post on this forum because I'm configuring cisco UC320 (Latest Firmware 2.3.2)I use the UC320 only with SIP account.For the most phones, I configure a inbound calling with specific inbound number and I check the case "use <number> like call I...
Hi,a customer of us, wants to use Cisco Phone over WLAN. The WLAN AccessPoints have no VLAN capabilities.Is it possible to configure a UC540 without the use of a voice VLAN?Can I use the phones inside the data-vlan?regardsMatthias
I have the SPA525g phone, its added as an extension already, I am having trouble downloading the anyconnect vpn client software, it says I need a service contract? I followed the attached guide, I do not have an ASA for this, even at my office. I h...
I have two SPA8000, in the CCA one of then is recognized by the systema and I can configure the extensions users, etc., but the other one is not possible to add, the button to add another FXS Gateway it's just disable. If I go to the topology view i...
Good afternoonI am thinking of implementing a Unified Cisco Communications environment.I will use UC500 on main office and 886va-e-k9-wlan on branch offices.In branch offices i will user Cisco SPA502G phones. Can i plug the phones directly to 886?Ho...
Hi All.I've come up with some questions and can't find the proper answers for them. I'm wondering if somebody can help me with answers.1) How can I check how many simultaneous calls can UC500 handle through SIP trunk? How many users can be on the cal...
Hello guys, So we have a client with SPA525G2 phones and he wanted to have a wireless headset on a few of them.I got the Plantronics CS510 headset along with the APC-45 which is required for the EHS feature.Now, the problem we are running into is tha...
I recently upgraded my UC560 to 8.6.1 and now my SPA525G2 will not connect and when I reboot it or factory reset it, it hang's up. I have load SPA525G-7-5-4.bin on the UC560. I have verified the switch port is good by swapping phones (SPA514G). I hav...
I have recently setup a UC540 with SPA508 handsets and am looking for a way to alter the ring tone to differentiate between external calls and internal calls - is this possible?
I've been trying to attach a Pantel VoIP door phone to an existing SPA9000. That was not a trivial task as configuring the Pantel VoIP to register with the SPA9000 as an extension results with any other extension being able to call the Pantel VoIP wh...
I have a client whose call flow is as follows:Main number -> Floating Extension (for day/night toggle) -> Auto Attendant -> Option 0 for Operator -> Hunt Group 1 -> Hunt Group 2 -> General Voicemailx501 - Hunt Group 1 - currently only contains the m...
Hello ,I am living in Saudi Arabia and when we receive calls caller ID not showing .I use uc540can you please advice ?Regards ,
So is there a way to do this? Can I route the 1 FXO to FXS for incomming calls (and plug fax into FXS) or something like this and then use that line as an outgoing line when not in use?I don't need step but steps but the basics of how something like ...
Hello,..Does CP-6921 Phone accept to take enhanced license instead of basic license if not available ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: