Voice Systems and Accessories - Small Business

Dear People, I recently bought a phone adaptor cisco SPA112. I have to tell you the truth I have at the beginning many problems to get my analogue telephone working. I even call my internet provider and we were a couple of hours without success. At m...

Dear Experts, I recently bought a Cisco SPA112 to convert the digital signal to an analogue signal of my phone. After many trials and settings it works well.  However I had recently a problem when I tried to communicate to a central telephone number...

Hi everyone.I am having an issue with a 3905 handset connecting to a BE3000 running 8.6.4. All of the other handsets I have tried receive their VLAN ID via LLDP and connect to the system without any problem. The 3905, however, will not. It seems that...

Can someone please explain why my VOIP service becomes unusable after 1 or 2 days.  I have purchased the SPA112 unit.  The problems arise when Call Forwarding numbers (17 digits) appear on my Call Forwarding Tab.  I delete these and the VOIP works ag...

Hello Cisco community. I have an office that I manage the voice systems for, and we use the 525G2 IP phone, with an attached SPA500S Att Console. A few of our phones will not keep the provisions I enter in for the SPA500S. Specifically, they continu...

HiSince April 2010, we have been using a Cisco UC520, and for the last week or two, the cooling fan has intermittently gone into very high speed (and noisy) for no apparent reason. Some days it can do this a few times within a short time frame, and o...

Hi Cisco Support Community, As a church we have found the UC560 system a good fit for our needs.  There is one piece we are working on finding a solution to.  During our services over the weekend, it would be nice for all the phones to be "on" rathe...

Can I use my SPA504G phones with a Cisco 2911 router....I mean is this even possible...if so then I will ask how! Thanks Don

Dear Support Command, I am a user of the SPA232d - I am pleased to note the high level of flexibility and value of this product. I am using it for about 8 months, everything I managed to configure with Asterisk (run on Synology Disk Station), PSTN (...

Hi all All my phones have the 7.5.2b or 7.5.2 firmware version, I'm considering if I should do it. I'm afraid if anything goes wrong I would like to know if there is some way to downgrade the phones after that I had upgraded them. So if I can downg...

A customer has several SPA504g phones. between all of them ( besides their directory number) they share xx08 and xx09. When pressing the line buttons while switching in between the phone numbers it will say 'trying line seizure" and the line will sta...

This is a older post which didn't answer correctly,https://supportforums.cisco.com/discussion/11469356/spa-504g-transfer-stopped-incoming-callsLet me explain the situation again as in the old post;1) A call comes into the SPA (call A).2) The receptio...

The online documentation refers to a Blind Transfer (BlindXfer) softkey, but our phones don't show this during calls. Does this have to be programmed in? Thanks.

We deployed 100+ SPA502G/SPA504G phones. Some users have problems with the soft-buttons:On call the "xfer" button disappears and only a  "Conf"  soft-button is showing in the middle of the display. Users can't transfer a call anymore.This happens now...