Voice Systems and Accessories - Small Business

I have an installation with three sites, connected via VPN, each with a UC-520 and using SIP service.  The headquarters handles all incoming calls and the desire is for the other two sites to have the HQ's phone number displayed as the outbound calle...

Hello,We have a UC520 and want to setup an extension for inbound customer emergency phone calls with the following actions/behaviour:Customer calls in and dials extension 456System tells him to "Please hold on while we ty to reach a technician"The sy...

Hi all,We've just installed a UC560 for a client and we're experiencing the same problems as described in this thread (conversation stops in one direction for 5-10 seconds at a time).https://www.myciscocommunity.com/thread/2662?start=0&tstart=0There ...

We are using a UC520 in our office, and i am currently stumped.     I am trying to make our voice mail have the ability to kick people back to our auto attendant. When someone calls an extension and hears the voice mail message describing that they a...

Hello,I am trying to setup a UC540W-BRI-K9 with an "Anlagenanschluss" BRI in Germany. This Anlagenanschluss has a 100-number-block of public numbers assigned to it by the provider (1234.00 - 1234.99). When I enter this range in CCA, it says there wer...

I want to use the standard ring for an incoming Octo line, and set the local extensions to use the feature ring ... it doesn't seem to be working as the customer is reporting that they both sound the same ... it is working via my remote IPCUM ... any...

Hello there,I have just got a SPA941 and I am sure I saw somewhere that you can upload your own mono Bitmap image. Can this be done?If not, I am only a basic user, can I not use the Firmware for a SPA942?Many thanks in advance.Aaron.

     Toss it out the window and it still works!!!http://www.youtube.com/foxivaxi#p/u/7/sBYh0mmZLxI

I am trying to install CallConnector Server and am having problems importing my ephone list from CME to the server setup wizard.  please let me know what additional info you need.  thanks!

Same problem posted in "SPA8800 firmware bug"Nat Mapping enable " yes" by default, not allowed to disbale ofr line 3,4,5,6,7,8.need urgent help..

We're running a 525g with a side car using sip. 7.1.7 works fine, when you hit a side car button during a car, it performs a blind transfer, after upgrading the firmware, the button simply puts the caller on hold and picks up a new line.

Hi,I assume the UCC server and client are suppose to show a person off-hook, but ours does not. I have debugged the RADIUS server and I do see the UC500 sending the RADIUS message to the UCC server, and the UCC server receiving the message, but my av...

I have just installed six SPA942s, one SPA9000, and two SPA400s onto my network.The phones are all configured with various combinations of other users on line buttons 2 throuth 4, all with BLF, SD, and CP.The problem is that when all phones are reset...

Hi,I searched on some Cisco sides for the SPA3102 Admin User Guide.But I found only a generic ATA Admin Guide which did not help in my case.Please tell me, what are min/max values forSPA To PSTN Gain:PSTN To SPA Gain:Thanks

Hello-I have searched this site and tried/checked multiple suggested solutions that I found but I can not get our MWI light to show on any of our phones.I have checked for the three dots behind the MWI extensions (we have 3 digit extensions).I have c...