VPN

So lets skip the VPN authentication, connection parts. I already have a connection to the VPN and can ping all the computers on the remote network. All good there. Using only a Win7 VPN Client connected to an ISA570.The problem is in my VPN settings....

We had a single T1 line going into a PIX 515e and I was able to connect to the network using the Cisco VPN Client software.  We increased our bandwidth to 6 T1's using a Cisco 2801 to bond the 6 T1's.  I changed the outside interface on the PIX 515e ...

hi i have a virtual ip sec tunnel setup to a sonicwall that appears to have a working active phase1/2 but the tunnel interfaces protocol is down and thus i can route traffic. I know this virtual ipsec tunnel works 100% to another cisco router but its...

Dear Experts,We have around 50 nos of Remote Access VPN profile and 8 - 10 nos of Site to Site VPN tunnel on ASA 5540 device. 2 ASA s are there.Problem:When we have created new Remote Access VPN profile using wizard whre on 1st screen tick mark is un...

I have a cisco 2821 router. I currently have it setup to accept vpn connections from a cisco client which uses the 172.16.4.0 subjet for vpn connections. I also have nat overload setup for my local lan of the router so my internal servers on the 172....

Hi,I'm running DMVPN together with IPSEC with on a Cisco 1941 with the (new) ISM VPN Module.My problem is that when I enable the ISM VPN module, then the DMVPN tunnels refuse to come up.ISAKMP is OK, the IPSEC tunnels are OK, but there is no outgoing...

Hello every body,We have one office in Milan where we encounter the folowing situation, the spoke router 1921 sits behind the isp (fastweb) router. The problem is that the tunnel is UP Ipsec/ikev2 UP  but traffic trough the tunnel works randomly and ...

I'm trying to work up a DMVPN solution, I'm not crazy about a PSK for all the sites.  I'd like to work with RADIUS and XAUTH in order to let me disable a remote S2S VPN simply disabling a specific users on the radius.Is it supported?

Hello all,I have a small query that I hope someone knows the answer to.We have an ASA 5510 on our side, from which we need to create a tunnel to a new clients ASA 5510.However, I have multiple (sub) Interfaces configured on our side, one of which is ...

Hi,I have a user who supports two different clients. Client A has Software RSA token which is installed in the user PC and the Client B has a hardware token.Now both clients are still on Cisco VPN client software(not yet moved to Anyconnect option). ...

We have a client who uses Windows 8, with the AnyConnect Version 3.1 client.  Connection works fine, but when user disconnects and hits reconnect, it fails every time until reboot.  So something doesn't sound correct, has anyone run into this and if ...