VPN

Hi all - hope someone can help.After testing many things it still not working :-(Here is my little desk setup..And my ASA setup see attached file..My problem is that the client can't access anything on the inside also the other way around:- no ping V...

HI,I used SDM 2.5 to configure a site to site VPN from my 2811 to a branch office rv802. It almost works!2811 network is 192.168.10.0/24; rv082 network is 192.168.1.0/24From the rv082 LAN, I can access anything behind the 2811, but traffic originatin...

The built in help lists CIFS as one of the Auto Signon types, however in my drop down list I only see basic,ntlm and ftp.I have attempted to add cifs urls but it does not seem to work....I KNOW that for bookarks I can pass the credentials in the URL ...

I seem to be having a weird issue where I am able to assign an ip address from a local pool if it is part of a different subnet than the inside interface. But if I try to create a pool where i use a portion of the subnet that is on the same subnet as...

Hi,We have site to site VPN between two locations. We plan to have HD quality IP-Address based, video conferencing between these tow locations.Considering that voice to be reproduced  should not exceed delay of about 150 mili seconds how practical it...

I have cisco 3825 Router and . Everything is working fine.  my vpn group and VPN POOL  is locally created in Cisco VPN router but users are authenticated through ACS, AAA server. Now I want to assign the static ip address to VPN Client. Everything is...

I recently switched to Windows 7 (32bit) and was able to get the latest Cisco VPN Client "vpnclient-win-msi-5.0.06.0160-k9" working with no issues.  Iused it with several connections very successfully. Two days later, I can start the client but the c...

Hi Someones that have any Link or config exp of ASA55nn with VPN-tunnel to many remote sites.The remote sites should have a tunnel esablish between eachotherThanks for any insight.

VPN server is behind the cisco adsl 857w router/modem.From a remote site, we want to establish an IPsec VPN tunnel and a PPTP remote VPN access.#1. How to configure the 857w to bridge mode or modem only?#2. If 857w ramains as adsl router/NAT, how to ...

Hi,In one of our remote location, we have a dsl connection that is not really good (slow bandwidth and goes down a few times). We would like to purchase some other dsl lines and to find a way to load-balance those lines. This loadbalancing will suppo...

Dear all,I have recently lost my syslog event for client to site vpn connections. At the moment the syslog server side is set up and the asdm is pointing to it. I have set up the logging filter as follows:I am not quite sure what I am doing here I mu...

Can I run ASA 5520 as Active and ASA 5510 as standby ?Regards,

Hellos,I have ASA5520 and I have configured two ISP on failover mode if primary ISP goes down backup ISP is takes over and internet works fine, but Site to Site IPSec VPN SAs remains on primary ISP, it is not renegotiating with backup IP untill i cle...

I want to automatically reconncet my VPN client in case of disconnection. I have made changes in PCF.ini file. but it is not working for me.In VPN client software I have[Main]AutoInitiationEnable=1AutoInitiationRetryInterval=1AutoInitiationList=ENOC-...

I want to automatically reconncet my VPN client in case of disconnection. I have made changes in PCF.ini file. but it is not working for me.In VPN client software I have[Main]AutoInitiationEnable=1AutoInitiationRetryInterval=1AutoInitiationList=ENOC-...