VPN

I am running a pair of 5520 ASA devices in a load balancing configuration. I have multiple Remote VPN groups using these boxes and would like to use DHCP to hand out an IP address to all the groups but one. However, in the group configuration window ...

Hello,can someone help point me to how to configure dymanic vpn on our asa to only allow computer account register in our active directory? Only computer member of our domain should be able to login only. Thanks

Hi All,I have four VLANs on an 1811. I need VLAN4 which has wide open internet access to be controlled so it cannot consume all bandwidth when in use and if bandwidth is required from devives on any of the other 3 Vlans, Vlan4 would be scaled back to...

Hi, Somebody knows, where do I can to find a tool to migrate from VPN3000 to ASA??.I apreciate all information.Best regards,DT.

Has anyone had any luck with getting *any* version of the Cisco VPN client to work on Kernel 2.6.27.5-41.fc9 on Fedora9? There's a well-known patch available that's supposed to fix the makefile, but it gets errors. See two screenshots attached. C...

I am trying to set up site to site vpn between an asa 5510 and 5505. I ran startup wizard and VPN site to site wizard on both. When I try to ping the remote site it fails and no tunnle is brought up. The message in the log is"NO SPI to Identify Phase...

Recently we installed a WRVS4400N Router, set it up with no problems and were able to access the internet from all computers on our intranet. However, from all intranet and some internet locations we cannot access the router remotely. Even from the m...

Hi All,I've got a 1800 series router. Its currently doing VPN on a stick - eg site to site VPN's with remote sites internet tunneled back through main site. I dont have a proxy server at all. Internet is natted by a loopback interface on the 1800 ...

Hi,We use Cisco ASA5540's for terminating VPNS and use a standard site to site VPN configuation for 5 VPNs. However we have been experiencing a major problem with 1 of the VPNs that terminates on a Nortel GGSN device.After much debugging it appears t...

Hello,I am using the document "Configuring Cisco VPN Client 3.x for windowns to IOS Using Local Extended Authentication" to test a remote access to internal LAN.Everything works fine but when I define the users:username usuario1 password 0 passwordth...

Hello everyone,i have an expert problem:on a 7600 there is an IDSM2 blade. On two gigabit ports from the 7600, configured as L3 ports (no switchport) there are ip addreses configured and there is OSPF runnig with 2 other equipents.The sniffing is con...

I keep revisiting setting up rdp over VPN with a pix 506e. It works, then fails, I give up, try again, etc... Anyway, I am able to establish the vpn. However, I can't consistently connect to one of the machines on the inside. Here is my config an...

Hi guys,I need to permit some user have to access read only to all configuration of router, show running-config. In this moment I wasn't able to permit this.How do I do this?Thnaks