VPN

I have setup a client remote VPN but can not reach my internal network. The Client is assigned a default gateway which i did not specify in the config. No nat translation is also taking place.I also note that my Client has an IP in the 192.168.x.x ra...

I have a ASA 5510 that until recently has successfully connected all Cisco VPN clients. However there is now a group of users who have moved premises and cant gain access. When I switch off the IKE Peer ID Validation, using a Pre Shared Key, it works...

I am trying to install VPN client onto server in question but I am getting an error during installation, something about deterministic adapter .... Please help.

Hi,I was just reorganizing my start menu, and discovered that if I move the location of the 'Cisco Systems VPN Client' folder from the root 'All Programs' to anywhere else, then when attempting to run the client, it just launches the installer, re-in...

Hi AllI have a 7200 series Router and I have just had a wierd crash...Debug from console @ crash time attached below - Any ideas ???Thanks Malcolm

Hi everyone,I am trying to make a site-to-site VPN between our office and the boss' home. They both have ADSL with dynamic IP addresses. The office uses Cisco 877w router. At home is the Draytek 2800. Has anyone had experience with these devices? I d...

Is there a way to kill/clear a single TCP connection on Pix/ASA. I have a user who has hung connections to a server behind the firewall. His session idle time on the Show Connection CLI output is incrementing. I want to kill that session/connectio...

Hi,I have ASA 5505 with ASA v 8.0.3 and ASDM v 6.0.3. The VPN connection works, the client receive the IP from the define pool but the default gateway is not correct. Is it possible to define the gateway in the pool ?thank you

I have a 3020 concentrator. It has been a perfectly fine frond end to our Citrix system for a couple of years. We recently decided to upgrade Citrix from 4.0 to 4.5 on two presentation servers and the front end web server.The first thing we noticed w...

Friends,I gonna configure ipsec tunnel between to sites. I want that tunnel remain up almost all the time. For this if i configure "crypto ipsec security-association idle-time" to its maximum value, is there any issue doing this. Means i want to not,...

We have a Pix firewall running 6.3(3),currently it is configured so that inside desktops NAT as PIX Outside Interface IP and hit internet .We are planning to establish a Site-Site VPN btw us and another company ,The other company is insisting that w...

I need to setup a vpn between our main office and a remote user using his verizon fios internet connection, he uses this service for both data and TV. Verizon provided him an actiontech MI-424-WR router. * Can I setup gre/ipsec tunnel behind the acti...

I'm trying to setup a VPN configuration with a company that has a 3020 Concentrator and we have a PIX501.We currently use PAT for all communications with the outside world (except with a few servers that have their own dedicated IPs, which we NAT). ...

Is it possible to see tunnel uptime in router or pix firewall...appreciate your help...Regards,Krishna.

Hi all,This is my problem.I have a site-to-site VPN between a PIX 501E and checkpoint (nokia platform) running in simplified mode. Simplified mode means that the outside interface of checkpoint is part of the encryption domain, hence, when I set up t...