VPN

Hello,I need assistance in configuring a VPN in a Cisco 831 Router. I do not have any experience in configuring routers and VPN's, and would appreciate if any one could help out. I would like to connect three Laptops to the Cisco 831 via Cisco VPN ...

Hi!Why can?t i reach resources on the Inside interface? Thanks in advance!fixup protocol dns maximum-length 512fixup protocol ftp 21fixup protocol h323 h225 1720fixup protocol h323 ras 1718-1719fixup protocol http 80fixup protocol rsh 514fixup protoc...

We have a NT4.0 tacacs+ ACS server that we want to turn off, permitting connections with blank usernames and passwords (or fictious). Our clients actually connect to us via PPP/ISDN with a username/password pair, in chap. Is it possible to disable pp...

HiAnybody knows if Downloadable ACL's with the AS5350 and ACS work? I tried it with ACS 3.3 and IOS 12.3(11)T11, because i red that this feature should be supportet on IOS from 12.3(8)T on. But it doesn't work. When I debug the radius authorization, ...

I'm looking to create a vpn connection between one small branch office and our main location which. The branch office has cable connection. The main office has a dsl connection with a Pix506e. Two other offices are connected to the main office, on...

HiI have a VPN 3000 Concentrator, and I would like to know if it can be implemented in this equipment source and destination NAT in the same way it can be implemented in Cisco routers.I need to access to devices in the public network from devices loc...

We have a few PDA's on trial and am trying the bluefire VPN client. This did work for a while but now it won't connect.The only thing I can see in a isakmp debug is the following -:ISAKMP (0:0): sending NAT-T vendor ID - rev 2 & 3ISAKMP (0:0): constr...

We are having a 1Mbps leased-line, i want to know, what kind of technology that can be. Thank you in advance.

Hello colleagues,I have a PIX 525 running 7.1 code. I have noticed users on the Cisco VPN client cannot access our networks across the wan from our corporate datacenter. I am attaching my config since it is fairly long.I am thinking I need the foll...

Hope someone can help. Trying to setup a VPN between my two sites using 1800 series routers. I used SDM to setup the router. The problem is this, I can ping a device at the remote LAN from any workstation, but if I ping from one of my servers which h...

Hi!I'm trying to implement WebVPN using the SSL VPn Client to a ASA5520. The problema is that after the automatic instalation of the SSL VPN Client it gets frozen and says it can't connect. My WinXP Event Viewer say "The Local Security Authority cann...

I have configured site-to-site VPN with PIX515e and PIX506e. I have basically established the connection and the vpn work fine. But after deploy for about 2 weeks, I found that the connection is not stable. My internet connection is stable but my VPN...

Cisco vpn clients connect to ASA. Drop tunnels randomly. 412 error code. Must re-establish tunnel. Can be up for 3 minutes or 5 hours, no pattern to this.Any ideas would be appreciated! Thank you!

I am a newbie when it comes to Cisco equipment. We have a PIX firewall (506E) and have clients using client VPN software. Users VPN in to one site.Everything was great until a couple of weeks ago.I have a weird issue were our users who use VPN clie...

Pix 6.3 had a fixup of esp-ike that worked with pat. It appears that this is gone as of 7.0 code. It only appears to work with nat? Am I correct.