VPN

I have a doubt in PIX FirewallCheck this sample config:------------------------Nat (inside) 0 access-list testAccess-list test permit ip host 172.20.128.133 anyThis mean the source 172.20.128.133 is allowed to access any destination without nat?Wheth...

Hi, I use ASA to setup site2site VPN, it works fine, how do I allow VPN client which terminate on ASA and allow them to access site2site VPN on the other side?Thx

I need to know how to enable on a PIX 501, a source initiated VPN session via Cisco VPN client within the inside network through a PIX 501 to the internet and into another PIX 501 on the remote end to the remote internal network. I can establish a V...

We have an IPSEC tunnel to a location over a DSL line at the remote end? This is the secondary (backup)We are debating whether we should try to monitor the router on the remote end via snmp? Currently, we are pinging it for availability. Please let m...

Hi,I have 2 ASA's in Active/Standby setup (context mode=single) that I am trying to configure for VPN load balancing. I have configured the appliances identically as follows:vpn load-balancing interface lbpublic Outside interface lbprivate Inside clu...

Hi,I`m having problem with certificate import on FC5 in VPN Client Version 4.8.00 (0490).I`m trying to import certificate.pfx and still getting error message:"error: unable to import certificate from path: /somepath/certificate.pfx"Root certificate (...

Dear all, I have 7200 series of router, 3500 series of switch, firewall 520 &535, I want some software that can monitor it memory (CPU), so please help me. Thanks; Jitesh

I'm still realatively new to CISCO and have searched the question archives for similiar answers. Then again perhaps I'm not using the right search criteria.I have a ASA5510 and so far primarily use the ASDM as I'm still very much a novice yet at usin...

HI,I have two routers at location A which are connected to Site B using two leased lines. I need to run IP Sec Between Location A and Location B.I want to know if i can configure the virtual IP of the HSRP Group pointing towards the LAN of the Locati...

Hello,Can I have a static crypto map be used for redundant peers using the same crypto ACL? I have an ASA with a static crypto map to site A, but if site A fails I would like it to establish IPsec with Site B. Is this possible? Is there anyway to con...

I have a Big problem with RBE ,I use RBE to assign static IP to my adsl user :interface Loopback0 ip address *.*.*.* *.*.*.*!interface ATM4/ima3.1 point-to-point ip unnumbered Loopback0 atm route-bridged ip pvc 0/1001 encapsulation aal5snap! when I ...

I have a central 3000 Concentrator connected to 2 private LANs. It sits behind an Internet facing PIX which is using NAT to NAT the Concentrators outside IP address to a Public address.The Concentrator is to use an IPSEC VPN to a remote PIX.Do I have...

I have an existing IPSec SA established between a Cisco VPN 3002 Hardware Client and a Cisco VPN 3000 Concentrator. A user behind the VPN 3002 device has a laptop with Cisco VPN Client Software and is attempting to establish an IPSec over UDP sesson ...

I'd like to configure an 837 running 12.3(11)YZ ip plus for IPSec passthrough. Is there a configuration guide available on CCO? I can only see sample configs for doing this on a PIX... thanks - all help greatly appreciated!