hi,I have 3 of these modules.with 1 module, when I configure a line and I connect to the line I get only a black screen.when I do the exact same thing with another module, (configure a line on the 2nd module) it works fine.my question is, how can I k...
We have a number of ADSL connected remote sites with IPSEC tunnels terminating on the PIX firewall at our central office.This morning, we lost connectivity with one of the ADSL connected sites.I've checked the router at the remote site, its up and ru...
I am having a problem with several clients using the Bell Sympatico client and various versions of the Cisco VPN client getting disconnected while working remotely. They are not sitting idle but are in the middle of working when everything stops wor...
Hi,I am using pix515 and 506 (v 634) with pdm (v 302).I can get a site to site tunnel up and going ,although if I want to add more than 1 tunnel, it's not working.I get the following error:[ERR]crypto map outside_map 40 set peer 83.206.14.109 WARNING...
Is there a command that will show me if the lan to lan vpn tunnel is actually up on a 1720 router? I noticed that if i type "sho crypto map rtp" it really shows me the configuration but not if it is up or not. Anyone know a command to check the tunne...
HelloI have a setup with a Zyxel 650R-31 connected to an ADSL coonection. behind the Zyxel I have a Cisco PIX 506E connected. I have setup the zyxel to forward all ports to the PIX IP. The port forwarding works fine (WWW, FTP, SMTP and so on). PPTP t...
Hello all, I have a PIX 506 with 6.3.4 and I terminate IPSEC based vpn on it. I get an IP address when I establish the VPN, but I cannot ping or communicate with any of the internal network. I know I am missing something simple, but I just can't se...
We have purchased two PIX 515E Firewalls about a year ago, and I want to enable Remote VPN when I am away from the office.According to the documentation, the PIX firewall "includes a free unlimited license for the highly acclaimed, industry-leading C...
Hi there, I got a PIX firewall, which users form IPSec VPN tunnel with it. User Authentication is performed by a ACS server via Radius protocol. IP address for VPN user is assigned by PIX Firewall. There are two different subnets of IP Pools for t...
Hi, I've configured a VPN 3000 to retrieve IP's from a DHCP server. Works fine - just had a query. When I look at the MAC address of IP that has been selected from the scope it comes up with the VPN MAC address + 9bytes on top. Does the VPN 3005 "spo...
Hello,This is the second time I start this conversation, only this time with a little bit more information. Hello, We want to migrate 30 computers with modems in it. Currently they dial into a NT server but we want to migrate them to a Cisco 1841 wit...
Hi all.I've got a ROUTER 2651XM with an IOS Version 12.3(8)T3, and a Voice Card for 2 ISDN BRI. The voice gateway is connected, at the other side, to a CallManager.I'd like to terminate ANY CALLS after 15 minutes of conversation... How and Where can...
- i have a cisco 836 adsl router.- i have a adsl line over isdn- i have a alcatel speedtouch 570i wich is working fine.when i plug in the 836 i dont get a carrier detect.how is that possible.thanksfrank
