Hi, I'm looking for some free VPN implementation guidelines documentation. I found http://www.cisco.com/safe a very good resource...but any other suggestion?Thanks!
I have a user from another company that needs to access his Company VPN, which is a PIX. He is having to go through our PIX to do it. I only have 1 IP at the site in question (its DSL). Can this be done.Thanks
hello forum.everytime i reboot the concentrator, it looses its ca certificate. digging into "file-management" it says:CERTS Error 0x2003 when getting file information CONFIG.BAK 24400 01/29/2004 11:52:32 CONFIG 24400 01/29/2004 11:57:50 MEMORY.TXT 1...
My Vpn connects fine using RADIUS however I get a "no translation group found for 'prot' src outside 192.168.9.129 (vpn local pool) dst inside (inside address)" No matter what proticol is attempted.I read somewhere that you cannot setup a static if ...
Hi,I've following questions related to time-ranges. Appreciate if someone could throw more light on this.1. Is it possible to use time-range in a crypto ACL on IOS? 2. On VPN3K, group-policies support time-range. Will this work same as time-range def...
We have finally resolved the issue of users login times taking about 6-7 minutes across the site to site VPN by adding the following registry entry to each client:[HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Lsa\Kerberos\Parameters]"MaxPacket...
I have a situation where the WAN router is a managed router and we would like to encrypt some traffic that goes over the WAN. If I put a VPN router in serial with the WAN router all traffic must pass through the VPN router to only to get to the WAN r...
Hello,Because this is far too much ahead for me as CCNA maybe you can help me with my problem:I have two Routers, a 1712 and a 1720. Both are connected to the Internet using DSL, PPPOE and are doing NAT.I have established a GRE Tunnel encapsulated in...
I using Cisco VPN client 4.0.3 to connect to a Cisco router. I have been able to login in and access the computers on the the private network but I can not access anything on the Internet while the tunnel is active. I would like all VPN client tr...
Does anyone know a good design and engineering reference on IPsec over mGRE tunnel?Such as, 1. what's maximum number of remote spoke sites per mGRE?2. How does Hub site forward pack to remote subnet ( like which ipsec tunnel should use to forward) si...
I am having a problem where the webvpn client cannot authenticate with the Radius server using mschap2 but PAP works. Is this normal ? Can anyone please provide the steps to setup the MS Radius IAS with the Cisco vpn 3000 concentrator ?Secondly, the ...
Hi!Just wondering if anyone is using DMVPNs? How do you cope with Hub failures? It seems that in all 12.3 IOSes Spokes do not answer NHRP "Resolution Requests" from the Hub when the Hub reboots (or "clear ip nhrp" is issued). This is unrelated to Bug...
Hi,We'v got IDSM-2 in a 6500 running the native IOS....The 6500 has a sup/pfc 2 and is setup to route traffic.There is multiple VLANS/private VLANS on which we already filter traffic in/out of the VLANS using VACLs.My understanding is it might be dif...
Does anyone know how disable http management access on PIX inside interface while vpnclient mode is enabled ?What I found was that when vpnclient mode is enabled. PIX will automatically enable http server and add directly connected inside network for...
