VPN

i am running OSPF using GRE tunnels (both OSPF packets and IPX packets are encrypted). The remote sites are using 3640 and the central sites are using 7200. All routers have hardware VPN modules.The WAN is using BroadBand Ethernet.The following mes...

The problem i am experiencing is the following. Remote access VPN from Internet to the Concentrator, is working fine and users are able to access the internal LAN. However i have configured a LAN to LAN VPN with a remote site whith very large private...

Guys,I am confused with all these different VPN clients available :-Cisco Secure VPN Client-Cisco VPN ClientWhich one of these will work under Windows 2000? I have a PIX 515 and want Win2k clients to connect to this PIX via 3Des.I got the latest Cisc...

We are trying to create a secure and redundant solution for clients to ftp files to our network. Can you tell me if it is possible to load balance 2 VPN Concentrators between two sites. The sites are connected by fibre optic link and both sites have ...

Hi Guys,I have configure the VPN Concentrator to do CRL checking but I am not sure if the Cisco VPN Client does any )there is no option for it to be configure???Does anyone know if this feature (CRL checking ) is only done at the gateway or the clie...

I am looking for a VPN solution to support 70+ remote sites. Each one of these sites already has a network in place. I would like to add a VPN enabled device at each site that will allow approximately 20 concurrent connections. I would like the de...

I am new to Cisco routers and this is probably basic stuff for most of you, but I need to know what steps to take to VPN through a CISCO 802 router from the internet so my remote laptop users can connect. My configuration is this Remote User---ISP--...

On Windows XP Pro when connected to an ISP via dailup and the VPN client is installed the computer freezes every 30 seconds or so. When the VPN client is uninstalled connecting to an ISP via dialup has no problems. I have the VPN 5000 Client 5.1.10 ...

We would like to setup VPN in such a way that remote users can VPN into the network and use their workstations as if they were on the LAN.Currently, I have setup the VPN IP pools for private addressing. When I establish a VPN connection to our PIX 51...

Does anyone know whether it is possible to terminate an IPSec tunnel in a VRF, on a 2600 router.Thanks

I am having a hard time to understand why some ISP say that they don't support IPSec. I got these explanations from two different ISP:1) IPSec does not work with dynamic IP address.2) All routers in between needs a special protocol.Does anyone has a ...

Hey all,I got something that I can't quite figure out...Got a Pix setup to do VPN, 6.2(2). Inside is 192.168.10.x, VPN pool is 192.168.11.x. I can get the client to authenticate no prob, Inside machines can ping and communicate with the client with n...

Here is the situation:A company has an office in NY and one in LA. Both sites have a T1 (serial/PPP) to ATT. If a GRE tunnel was established between the 2 sites, is it possible to packet sniff the traffic unless you are on ATT's backbone?

Hi all,We have added our cisco router a tacacs authentication for both login and enable. And created a user for cspm to be authenticated at tacacs. I can use the cspm username and password to be authenticated at tacacs. But when Cspm try to block an ...

I'm configuring VPN 3000 to VPN client, I would like to understand what the filter under group general tab is for. Thank you in advance