VPN

Hi, We have Cisco 2600, IOS 11.3 (T), I have done NATting for my Pvt IPs. We have also done a VPN from our office to one of our remote branches which is terminated on a PIX. For VPN our office is using IPs 192.168.57.0/24 and the Branch is using 92....

I would like to start automatiquely a VPN client (3.5) connection from my W2K server when it try to open a FTP session to a FTP server behind a PIX 6.2.Is it possible ...My W2K Server is directly connected to Internet (ADSL access) with a public addr...

Is tacacs supported on a VG200? I tried configuring but the commands are not seen - any advice

Can i have a h.323 call over IPsec tunnel useing easy vpn server funcation with 2600 12.2(8)T and VPN client?Thanks & Regrads

Hello,I have a ACS server and if I VPN in to the network I ping the ACS server .But I am not able to see the ACS server through network neighborhood .Also I am not able to see any of the shared resoucersIf I RAS in to the network I am able to see the...

Hi,Does any one know whether Ipsec VPN connections work simultaniously from multiple cisco vpn clients to the same concentrator through Dlink (DI-704P) gateway router?regards,jimmy.

Scenario: Using VPN Client 3.5.1 (B) behind a 2600 router doing NAT and IOS ver 12.2.(8)T4. Destination is a VPN 3000 concentrator. Client can authenticate and connect, but can't reach anything. Tried both no tunneling and udp tunneling... tcp tun...

Is there still a problem with Microsoft CA and the PIX reading revocation lists?

I have a client that can't get a static IP at one of its locations (for reasonable $$) Is there a way to create a Lan-to-Lan VPN using 1720s with one router having a dyamic IP?Thanks,Mike

I need to create a VPDN with L2TP and no encryption, for a total of 1200 users, and I can have some hundreds of them connected at the same time.I could only find documentation saying the max number of encrypted IPSec Tunnels with AIM & NM-VPN module....

I need to configure a pix to create a vpn tunnel to a Checkpoint firewall. I have configured pix and when I ping from an inside host on the pix to a host on the dmz of CP FW I get MM_NO_STATE when I issue the cmd sh isakmp sa. PIX appears to initiat...

why does this happen when i try to log on to a tacacs enable router?3d00h: TAC+: (1988742668) AUTHEN/START/LOGIN/ASCII processed3d00h: TAC+: received bad AUTHEN packet: length = 6, expected 724763d00h: TAC+: Invalid AUTHEN/START/LOGIN/ASCII packet (c...

I would like to implement a AAA service to manage our Cisco routers. What pieces of equipment do I need to install ?How are they working together ?

I configure VoIP through the IPSec tunnel between PIX 520 and the router 7201. The voice User Datagram Protocol (UDP) is marked as precedence 5 when leaving the voice router. Will the PIX keep the precedence for the voice UDP traffic after leaving th...

Hello, I am new to this forum, so bare with me. I am sure this discussion has come up many times before but I am going to ask again. I am including as much information as I can, in hopes that I will receive useful feedback.In the last few weeks I h...