VPN

Hi. I am in the midst of configuring a VPN setup. Head unit is an ASA-5508x, running FTD 6.2.2.1, administered by a vFMC running 6.2.2.1. I am trying to setup TWO types of client VPN:1. One for users who wish to manually connect from home, or an othe...

I did configuration FlexVPN AnyConnect-Eap as following guide: FlexVPN: AnyConnect IKEv2 Remote Access with AnyConnect-EAP I did configuration on 3 routers ASR 1001 IOS XE 3.16S. I enable BypassDownloader  and Disable Captive Portal Detection on the ...

Hi All,   I am using Anyconnect client 4.6 and trying to use ECDSA certificates. I've enabled FIPS mode in the local policy, but the client will not select any ECDSA certs in the store, if I put an RSA cert in it will let me choose it. I'm not convin...

Guys,    Need your help to understand the technical difference between client to site and site to site VPN?   How does a AP-> Controller and remote client-> Controller IP sec transactions will vary?

Hi all,   I'm having problems installing a CA cert on the ASA. The root cert installs fine, but the intermediate will not. Is there a character length limit for the CRL within the cert?   Debugging we get this output,   CERT-C: E ../cert-c/source/cer...

Hi All,   We have a simple Anyconnect structure in our environment where Anyconnect users are getting authenticated against AD for registered laptops. However, recently we could see some of our employees are trying to access our internal networks via...

Hello, I recently installed openSuse Leap 42.1 with the Linux Cisco AnyConnect Client (version 4.1.06020) . I'm using the GNOME desktop environment. When I'm start a new secure vpn connection the connection is available since I open or close a new t...

Hi! We are trying to implement Cisco FlexVPN SiteToSite, and trying out Certificate Authentication. My challenge is that we are using a Microsoft PKI solution with Offline RootCA, and a Issuing CA with NDES (http://www.petenetlive.com/KB/Article/000...

Hi all I need to do a L2TP/IPsec Client VPN from a Cisco Router (800 series) to a Meraki MX64. How can I do that? Are there any Configuration examples? Thanks for any advice. Best Regards, Daniel

Hi I am trying to establish some IPSec via VTI from an ISR to an ASA.With each step I got forward, I found the next restriction to VTI and/or ASA. I don't understand, why it is not possible to implement.   First my requirements/environment: - My bran...

I have a network which you can see in the image link below, I want to make VPN so that a client PC can access the email server as local network, (these two networks are under same building) Any reply is appriciated Thanks

Hi All,         I have Cisco 1800 router configured with remote access vpn. My internal LAN are 192.168.1.X and 192.168.2.X. Client pool is configured to be 192.168.100.X, I can connect to vpn and get the IP as per client pool, but can not access the...