VPN

Hey!,   I am making my final thesis about Cisco uBR10012 CMTS-system and its deployment for Metropolia University of Applied Scienses here in Finland. I would have one question regarding this system as I have been kinda stuck for a while. For uBR1001...

Hi all, I'm trying to create a VPN tunnel between my ASA5515 router and a DIGICOM 8E4571 Modem3G. Could you help me about this configuration??   Belove the error messages that 3Grouter returns me:   17-10-24 10:22:07 <3> ipsec: "IPsec_Tunnel_1" #172:...

Hi All,   Can anyone explain how remote access VPN works ? Especially when we configure IP pool, I see the IP pool configured but no route from ASA ? Can anyone explain how VPN works and how IP pool works in and out ?   Regards

Hello, I have a Cisco 2851 router - Configured SSH for an alternate port but it does not work inbound from the "world" - I can connect SSH internally using SecureCRT from inside my network - I also have other services that I cannot get to from the ou...

Hi , I am using CSR1000v as a VPN Gateway. Anyconnect as SSL VPN client. I can successfully connect through SSL VPN. However my SSLVPN-VIF0 is allocating to global routing table. I want to assign vpn client to seperate VRF. I have tried with Radius ...

I have Cisco RV345 and I need to use Cisco Anyconnect for only two laptops, so i can connect from anywhere --- my question is which license i should buy or do I need license? There are two anyconnect tunnels within the RV345

Hi guys, my customer (it's an ISP) is requesting a L2VPN solution that satisfy these requirements:   1) His clients, single homed via ME3600x acting as MPLS PE, want to be able to realize L2VPN p2p and p2mp among their remote sites spread geographica...

This may be my first post so I'll try and make it a good one. Been struggling with this for a while now, I thought I was being clever by using Bridge Domain Interfaces to add a bit of resilience to this design, now this choice seems to have come back...

Hi,sh crypto ipsec sa peer X.X.X.X ?What is the meaning of increasing send errors when I am executing the above command. I am seeing the send error count increasing and there is no change in"pkts encaps" & "Pkts decaps". This IPsec Tunnel is working...

Hi ALL,   installed Cisco AnyConnect Secure Mobility Cliet Version 4.2.04018, succesfuly connected to VPN, can acces local/remote LANS and internet. but when I disconnect from VPN there is no LAN/internet   Pinging 192.168.5.15 with 32 bytes of data:...