VPN

 We have an L2L tunnel configured between two Cisco ASA 5585Xs, and could use some help interpreting the output of "show crypto isakmp."The tunnel had some problems last week -- "hanging" and not passing traffic.  A coworker captured "show crypto isa...

Guys,I am having this issue with a number of clients. It is laptop related a rebuild resolves the issue.Any suggestions on what could be causing it?? Thanks in advanced.

I just configured my Cisco ASA 5505 to failover to a backup internet line when the main outside interface is down. This all works fine.Also, I have a site-to-site IPSEC VPN tunnel from this ISP-redundant ASA to our ASA in the datacenter. The failover...

Hi,I'm setting up SSL Clientless VPN with smart tunnels. When I allow all traffic through the VPN, DNS requests are resolved however when I allow only specified traffic through the tunnel the DNS requests fail. Any suggestions of how to resolve this?...

Hi all,I've been trying to troubleshoot this issue for two weeks.  I just need direction on where to look.  Or, if anyone has any experience with this issue.My Syn Ack is delayed.  It comes about 4 secs after the teardown, every test.  We've checked ...

There is a new firmware 1.5 form RV 180. It is not compatible with the RV 180w.   Will there be a Fimrware upgrade for RV 180W?

Please help! I want to set up a vpn site to site cisco 2091---juniper srx3400 but im having some problems..When i enter the command: show crypto isakmp sa       the result is:mm_no_state 0 active (deleted)Can someone please tell me what to do ? 

Hello, i want to creat an VPN beetwen 2 cisco routers. Can you help me ? Thanks a lot 1st  routeur ZURICH#sh run Building configuration... Current configuration : 2489 bytes ! ! Last configuration change at 11:43:46 cest Thu Jul 2 2015 by admin ! ...

Hey everyone. I have a 5555x that is giving me strange problems again ! I have 40-45 ipsec's to ASA 5505, 5510, 5550 and everything works fine execpt one ipsec thats drops.  The tunnel is IKEv2 (also tried IKEv1), the tunnel can initiate from the rem...

Hi Guys, I have configured anyconnect on my ASA. The client pc is able to connect to the network with anyconnect client gets ip address but cannot ping or access anything. Here is the config: DMZ1664 is outside interfaceDMZ1070 is inside interface in...

HiI need help trying to understand what I need to modify into config to pass over the vpn tunnel the voice vlan.I had this scenario one site (main) had the router for vpn and voice uc560 a branch office only the router with vpn, I already made the VP...

Hi,I am planning to implement Site to Site VPN  with two ASA 5505.But before purchasing i just want to know that, whether it is possible to configure site to site vpn  with two dyndns address one on each location. Thanks & Regards,Prabhat

Hello, please help me. i am successfully setting up using windows domain user account to login to clientless SSL VPN, but i don't know how to assign bookmarks to domain user. On ASDM,  bookmarks can only be assigned to local users. is there a way to ...

I'm building a site to site tunnel and every time I apply a crypto map to an interface, I lose connectivity.  I can't even ping the IP address assigned to the interface, even though it shows up up.  I've tried different interfaces, different routers,...