VPN

Hi All,I am facing issues with passing kerbros authentication through the ipsec vpn between my sites it seems failing  the same setup seems to work with MPLS vpn sites. I am having asa as my VPN device.Note : its is a new setup its not working from t...

I have been trying to set up a nested IPsec tunnel configuration, but am running into issues and need some assistance.I've attached a diagram and configuration files for the various devices.  The setup is currently built with Ubuntu VM's and CSR VM's...

Dear experts,I'm trying to configure my RV180 router to allow IPSEC remote connection (client-to-site), and I'm failing.My setup would be:client --> (internet) --> (public IP) router (private IP) -> local networkPublic IP: ISP address (fixed), let sa...

Hi allI've just deployed AnyConnect for a customer and presently running v3.1.0578. I've got the core VPN and NAM modules installed and everything is otherwise OK. However, the customer has recently just notified me that they are unable to connect to...

Are there any special character limitations for PSK's in ASA version 9.1? If so, what should I exclude from my password generator?

Hello,I have the following strange behaviour:I connect 90 branch routers (837/877/887) to my central hub (PIX515E ver 6.3) by VPN/IPsec tunnelsalso I connect 10 branch router to another central hub (Cisco1841) with same VPN/IPSec tunnels.I have no pr...

Hi,We are try to use two cisco 3925 setup a IPSec VPN Hub. Could you any one let me know whether 3925 will support Stateful Failover for IPsec. If it does. which document are best to referring to.  both router are running c3900-universalk9-mz.SPA.153...

Hey Guys,  I am trying to telnet my router but its not TELNETTing it; Router 1:IP  - 10.1.1.1access-list 30 permit 10.144.0.0 0.0.255.255line vty 0 5 access-class 50 in Layer 3 SwitchVLAN87 - IP 10.1.1.2VLAN88 - IP Address - 10.144.1.10 255.255.255.0...

i have a 5545-x with software version 9.1(1), and i am having problem with NAT and PAT translations.whenever i use an ip in a NAT rule i cannot use that ip in a PAT rule. I can accross this information on cisco.com" If you enable extended PAT for a d...

Cisco 2821 router with VWIC2-2MFT-G703 (a 2-port G.703 card), ISDN switch type is NET5, no DSPs are installed, IOS 15.0 I am trying to configure ISDN PRI for data calls only (no voice), but I get following error: vtpR01t(config)#card type e1 0 2 vt...

I have a site to site VPN between ASA 5510 and Windows Azure cloud. There is an Anyconnect VPN connecting to the ASA. I enabled hairpinning and allowed the Anyconnect VPN pool over the site to site tunnel at both ends. The ASA internal network can re...

Dear all, we are recently working with a RV042 router, with VPN group tunnel (connectig using shrew VPN). Last days the router was logging a few disconnections like this ("[XXX]" text replaced for security reasons)   Dec 9 17:02:58 2014 XXX VPN Lo...