Wireless

Hi, I want to check wlc5508 power supply serial nummer,but we only can check the  power supply status by "show inventory" or "show sysinfo" command.Is there any command to check the power supply serial number on CLI or GUI ? Thanks

Hello All, Historically when I've asked my reseller for WLC adder licenses they have quoted me the line items L-LIC-CT2504-5A &L-LIC-CT2504-UPG (zero value).  Now they are saying I have to purchase a compulsory contract item number CON-ECMU-LCT255A. ...

Dear All, Can we configure Cisco base wIPS (controller based) to the outdoor mesh ?If yes, what could be the test scenarios ?How we can test it properly, before going to meet the client. Thanks

I have 3 ap groups. 1st Floor, 2nd Floor, and 3rd Floor and each group has an SSID "X" assigned to it with a different interface. The problem is, if I go to the 1st floor I get an IP, but as I go to the second, instead of getting a new IP and Subnet ...

I've been working on a Cisco 3802i WLC. I am unable to ping the Management IP address of WLC. - I've followed step-by-step instructions from Cisco, how to configure 3802i WLC. - Configured with proper IP address, subnet mask and gateway IP address. -...

This is a stupid question but I am trying to understand. If you have a mobile router with cellular capabilities, do you still need a modem for internet access? When you can just access the internet through your mobile provider?  Thank you! nd Mobilit...

Hi,Hopefully this is a very simple question to answer. Has the bug: CSCvc13175 GLC-T SFP stopped working in CT5520 (1G Port down on 5520) been fixed in the latest 8.3 and 8.5 code releases. I'm pretty sure is has been but I'm just verifying it for a ...

I am trying to set up a few air-ap1262n-nk9 access points but am struggling to log in via console Port.When connected to my router, it gets an assigned ip address of 192.168.1.106 but won't connect to the gui if I enter that ip into the browser.Am I ...

I was looking into Radius profiling on the WLAN controller. I would like to make the recommendation that DHCP should not have to be required in order to do profiling. I understand that DHCP is required to actually profile. However, it would not be ne...

Hello guysi have 5508 controller in HQ , i like to install wireless network at branches, i have 3802 AP , any recommendations about ? ,  any specific configuration on Router of branch that will be come in the front of AP ?regards

Just wondering what Cisco's recommendation on this is. Also, can I take a backup of all my settings on an earlier software version and import them on a later software version?

PI 3.6WLC 5520, OS: 8.5.151.0 what does this mean?env_monitor.c:101 Check sensor fail: Octeon Temperature, errno 11, errstring Resource temporarily unavailable.I found it PI system log viewer thank you.