Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hey guys,Just need some opinions. So we have a community meeting where we are maybe 180 in an auditorium where I have two MR42's in place. Granted I've never had any issues before but want to know if 2 APs is considered "ok" for that volume of people...

kYutobi by Level 11
  • 19061 Views
  • 15 replies
  • 0 Helpful votes

We recently bought a new WLC. The existing WLC is running on 8.5.110. The new one came with 8.5.131. I believe that we need same OS on both WLC for HA. Interestingly , image 8.5.110 has been removed from Cisco website due to some bugs.So I decided to...

vishesh.lib by Frequent Visitor
  • 3765 Views
  • 10 replies
  • 0 Helpful votes

Dear colleagues, I have purchased a Cisco Controller 3504 with two APs, I have configured and installed the controller with APs, our clients faced an issue, that they have to re-authentication every day because the session is expired, also when I reb...

aram.fars1 by Frequent Visitor
  • 6292 Views
  • 16 replies
  • 0 Helpful votes

I am new to the 5508,,, followed all the config guides, and still cannot ping from the switch to the controller... 5508 port 1 is connected to 3750 port 13750 vlan 1 10.10.10.15508 port summ:Interface Name            Port      Vlan Id     IP Address ...

SSmart0324 by Community Member
  • 1238 Views
  • 3 replies
  • 0 Helpful votes

Hello Guys we wanted to reboot 8500 which is in HA mode presently (IOS 8.3.X), can we reboot primary and secondary controller separately to avoid total outage.What is the risk if we go with separate reboot ? What could be the failover time to seconda...

sainath9890 by Frequent Visitor
  • 3444 Views
  • 13 replies
  • 0 Helpful votes

I have an AP from my small business that I have since closed. I have a new job and where I am in charge of all things IT (and thus my name would not change on it). We currently have 2 Meraki AP's there and I would love to throw my old one into the mi...

olid by Community Member
  • 3907 Views
  • 4 replies
  • 0 Helpful votes

Hi all,I'm having a big problem with a WLC. There were 42 licenses. I uploaded 8 new ones but, after restarting the wlc, the count is still 42.Via CLI i did the command "show license in-use" and no result came out, nor the 42 licenses!If i go via web...

I have a separate VLAN for Guest WiFi Access with Splash Through Access, when getting authenticated and an IP Address I cannot connect to the internet. Anyone else every experience this issue, my Guest SSID is tagged with the correct VLAN.

John4858 by Community Member
  • 15037 Views
  • 13 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card