Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Insider User Research program

Labels

Forum Posts

Hi expert guys I have new AP CAP2702E-E-K9 but can not join it the current WLC After config IP, gateway and WLC address, it only show  Translating "CISCO-CAPWAP-CONTROLLER"...domain server (255.255.255.255) on the console screen Help me to check it ...

Ha Dao by Level 1
  • 1176 Views
  • 6 replies
  • 0 Helpful votes

I was able to configure 2504 wireless controller once configured I plugged in the AP to POE port on 2504, I see the AP with Flashing Green but 2504 doesn't see the AP, what could be wrong any guidance will be appreciated.

Hello, I would like to know your experience on the following. For a Warehouse, I have 2702(X) type APs, the ceiling height is app. 11 meters. Which type will be the best option ? 2702E with external antenna's - like the AIR-ANT2544V4M-R Omni gain :...

bschol by Level 1
  • 2346 Views
  • 3 replies
  • 0 Helpful votes

Dear Community, I am trying to configure a 2720i Acess point.when i configured 1130AG.I configured the e0 interface and was able to reached the browser gui for the rest of the configuration.Does tehe 2720i have a browser for configuration?In the att...

isaaco001 by Level 3
  • 690 Views
  • 6 replies
  • 0 Helpful votes

Hello, We have a 5508, ISE and Prime. Can I run a packet capture for a client and run the results through Wireshark at all? Thanks 

Hello Experts, I know there are many methods.... like: DHCP Option 43Brodcast Layer3DNSPreviously lerned WLC IP What is the sequence or priority LAP takes to discover. Regards

Hello, I've got some issues trying to get these new APs visible into Prime: AP model: AIR-AP1832I-E-K9 WLC: 5760, IOS-XE 7.5.3 Prime: 3.1 They register perfectly fine on the WLC, I can edit them, etc... but they can't be found on Prime even after a...

Hello Experts, I Just want to ask you regarding transmit Power level setting for Cisco 3702i access point. For some Testing of WLAN Signal coverage Mockup in my my porject , i converted cisco 3702i from LAP to Autonomous. Now as per data sheet , i c...

I have a customer that have none cisco softphones installed on thier laptops. In the softphone application we set the DSCP to use for RTP traffic to 46 to comply with Cisco medianet. This works well as long as the client is wired. Problem comes with ...

Review Cisco Networking for a $25 gift card