Wireless

Hello Experts,    What are the configurations that are retained with upgrade of Cisco prime infrastructure from version 3.1 to version 3.4?   Few of the options that we have in 3.1 are depreciated in 3.4. Not sure if we have any impact for the config...

I have AIR-CAP3502 Which works in an automous configuration I want to know how I reduce the transmission power to a minimum   Is the rest of the settings that appear on the screen here are good ? (Attached is a screenshot)   what is "Internal Antenna...

Dear All,   We have configured cisco 3650 switch and I am not able to add the AP, once I connected the AP, I am getting below attached error. Kindly advice     *%CAPWAP-6-DTLS_CONN_ERR2:Switch 1 R0/0: wcm: DTLS connection not found for AP 192.168.30....

If I had two datacenters that needed high redundancy, could I do an HA pair of 8540's at each datacenter for immediate SSO failover and, additionally,  set up geographic redundancy between the HA pairs?  If feasible, what would the licensing structur...

Hi,I have two WLC- AIR-CT2500-K9-8-2-170-0 , I need to do by  N+1 method, For this method, is HA-SKU license mandatory for this?                              WLC-1   Base  AP Count    Permanent    No expiry  25  Medium    in use                      ...

I am preparing a bill of materials for an AP install.  The AP model is the cisco AIR-CAP2802E-B-K9.  The antennas is AIR-ANT2524DW-R which is a dual band dipole.  I noticed the 2802E has 4 antenna ports.  Do we install an antenna on all 4 ports?  So ...

I have access point meraki but I am connected to a Cisco switch so if I connect the APs in the Cisco swicth in a trunk port the AP does not register in the dashboard.If I connect the AP in a swicth access it takes IP by DCHP and registers in the dash...

Hello guys   I have a WLC 5508 Software 8.0.133.0 and I configured the following SNMP Traps:   General: Link (port) Up/Down AP: AP Register and AP Interface UP/DOWN   But my monitoring team is receiving this trap KTS VOIP CALL FAILURE: "A "ciscoLwapp...

Hello all, I used WLC 5520 for our customer and he want to use the captive portal for guest user. i choosed the customized one When the user connects to WiFi, at the level of the captive portal he should fill in these two fields that are name and ema...

I have WLC 2504 (version 7.6.110.0). I would like to do HA with AIR-CT2504-HA-K9. How can I configure to do HA (N+1)?I cannot find any document that do HA (N+1) with WLC 2504. Thank you.  

Hello, I have already two 2802i. One as a controller and one as AP. The 2 Aironet are connected on the network with cable.Everything works perfectlyI need to add another 2802i, but impossible for me to connect this third by cable.It seems that the Ai...

Consolidating the steps for readers:   ssh to the cmx with Management IP and credentials of cmxadminType "su"Type "passwd <username>".It will ask for the existing password of the user specfiied followed by prompting the new password that you would li...