Hello, Can someone explain in detail how does the performance gets affected or improved by having a 3802i with 2GB uplinks rather than with only one GB link to the switch?, is it worth to run and pay for a second cable to be extended for this purpo...
Forum Posts
Hello, What would be data rates to only support 80211ac or to allow the max speed possible on the wlc.? Thanks
Hello Experts I am not able to find the roam history for wireless clients that are associated on flex mode APs. Is there a way out?
Hi all, I'm searching for a OID for have the number of AP and client/user connected on a Cisco WLC 44XX.Anyone know how to get this information?ThanksEnrico Pasqualotto
Hello, Can someone explain in lame terms what is adjacent interference and how to avoid it? Thanks in advance
Hi to All I need a certificate of iLac laboratory member that shows AIR-AP2808I was tested based on EN 300,328 and European standard. Thanks in Advanced
I'm reaching out to this community in hopes that I can contact an actual user of CMX Connect, Engage, Presence and Locate services whether you are using CMX in the cloud or on-premise. I am a senior network engineer for a large retail organization wi...
Hello, Can someone explain in lame terms what is the differences and advantages of using 20, 40, 80 and 160mhz channels and how each can improve speed performance and how is able to do this?, are all of these frequencies fully supported by clients?...
Hello, I hope everyone is doing well, quick question what is the best practice to follow when it comes to Rogue AP's. What to do with the rogue access points found by the WLC? Thanks
Hello, When is it recommended to configure LAG or Link aggregation on the WLC? and what does this exacty do? does it increase the speed or traffic between the AP's to WLC to the Switch?. Will LAG improve speed performance for the AP users? How doe...
hello everyone<<< I using CNA (Cisco Network Assistant ) I want to do backup for my devices but i do it For each device alone ,, how i do backup For all devices one time
I am making a script to speed up the process on changes on a wlc. Could someone help with providing the cli command for the following.. enable/disable the radio on 802.11a add/removing channels from the DCA list Wlan Area Authentication priority ...
We've been noticing this behavior on the MR42 APs that suddenly it loses power (directly-attached to PoE port of MX65 appliance) and the only way to recover is to reboot the MX65 appliance. Checked the CAT6 cable - good. Nothing extraordinary is show...
Hi, We've had an odd thing happen in that public wifi that we host at one of our offices has gone down since we had an office power outage. The primary wireless controller at the office has come back up as normal, however, even though in the mobility...
We are trying to be more prudent on what subnets have access to our WLC for PCI compliance. We have created a deny ACL on the management ACL of the wireless controller but I can still ssh from a subnet we have denied access to. What gives? We obv...
