Wireless

If the UPoE source is working in forced mode, will Cisco APs, that can use UPoE, accept power over all four pairs ?We would like to use a mid-span passive (no handshake) four pair 60W inserter. Thanks, Vic.

i have a cisco router. i have another router (linksys) which is connected to the cisco one. the linksys one is wireless. anyhow, how can i configure these router to let some ip adresses thru freely?tnxyoni

Hi allWe've had quite a few problems with RRM, in particular when we've previously engaged contractors to do AP Placement designs they've failed to consider RRM. So they do their survey with test APs on static power levels, but because of RRM those p...

Hello, Just to make sure...Azimuth for this AP does not really matter, since it has an omni antenna. Is it correct??Elevation 90* up means that AP is staying on the bottom edge, 0* up means the AP is laying on it's back, right? 

Hello  I'd like know on Cisco AIR-CAP2702 and air-cap1700 and 3700 , how many SSID are supported ?   regards Helpdesk    

I can't find the list of compatible access points with AIR-CT2504-5-K9 network controller.Are these compatible:AIR-CAP702W-x-K9 - Dual-band controller-based 802.11a/g/nAIR-CAP702I-x-K9 - Dual-band controller-based 802.11a/g/nAIR-SAP702I-x-K9 - Dual-b...

Hi All. I have configured ISE for all my wireless clients, and everything is working 100%. The client now want to connect mobile devices to the same SSID.  and get the error below. How do I stop ISE from trying to push the Policy & Agent down to the ...

Hi, we are having an interesting issue, in production area, we all running 11 APs with flexconnect mode, they are in the same AP group.some of SSIDs are in local mode centrally switching, but only one SSID is flexconnect mode with local switching. Th...

I do have several AIR-LAP1041N-E-K9 APs joined AIR-CT8510-K9 running 7.6.130.0 in Flexconnect mode. These APs were used in Local mode on an older controller before.I had an issue that the APs were in Admin disable when they reloaded. I had to enable ...

Hello Experts,Recently we have deployed Cisco WLC 5508 in HA mode,One AP AIR-CAP1532E-A-K9 configured as Root AP ( Parent AP ) wired connected to WLC for Backhauling and several AIR-CAP1532I-A-K9 ( Child AP ) configured as Mesh AP without LAN wire, a...

Hi all,  I am wondering if the following is possible on a Cisco Mesh Network.  Existing RAP & MAPs provide SSID Kerrieswifi. The MAP access point has a switch connected. The switch has a 3500 Lightweight Access Point connected providing a new SSID ca...

Hi, we have an issue whereby the coverage provided by the 1600 AP is much poorer than when the site was surveyed using a standalone access point. As part of testing I have manually changed the power assignments to all be set to maximum rather than us...

Hello, VLAN Transparent is disabledEthernet Bridging is enabledOnly the native vlan is not passing, cannot ping between 10.1.1.0/24RAP tested with normal port as well as with trunkportMAP tested with trunkport Tested with WLC4404 7.0.252.0 and WLC250...