Hey Community! I'm excited to share something we've been working on that I think will really resonate with many of you managing wireless networks today. We just released the Cisco State of Wireless Report 2026, based on insights from over 6,000 wirel...
Forum Posts
I need to pre-download a new image to 600+ ap's but I don't want to do all at the same time or one at a time. Is it possible to pre-download the image to the AP's in batches of 20 to 50 at a time?
Hello, Just a question what is exactly the "Emergency image Version" Best regards
How to reset WLC 2504.
Dear Experts, I have deployed WLC 3504 along with 22 Access Points which are 2802i and 18 Access points were deployed at HO and 4 access points deployed on remote location which are in different subnet like: HO 192.168.9.x and Remote locations 192.16...
Hello, I need to replace one Cisco Wireless access point. I had one Cisco AP AIR-AP1252G-A-K9 is dead now. Right now I am checking to see if I can install Cisco AIR-CAP2602E-A-K9 Access Point. I need to have bridge option available for the new acces...
Hi Guys, I have an environment of WLC 5520 with 3802 and 2802 APs on development, will go production soon. The WLC currently running 8.2.166.0. Based on your experience, should I upgrade my IOS? I looked into Cisco software research. The page tol...
Resolved! Operation State Down
Dear All I have a question about troubleshooting " Operation State Down: Base Radio MAC:7c:95:f3:6c:c6:30 Cause=Unknown Reset Status:NA " This AP is break down in everyday. Pls support us or give us for information how to fix it out. Pls chec...
I have APs model air-cap1531I-N-K9 and a WLC 8540 version 8.x try doing the capwap manually but it is the same errorbut the APs fail to join in the WLC The message that the AP shows me isWhat I can do ?
Resolved! Displaying WAP hostname on CDP
Hi,Trivial question.... I've configured hostname on the Dashboard for each WAP, but when I looked at the CDP neighbors on the switch the WAP is connected to, I only see the WAP's MAC address as hostname. How do I display the WAP hostname I configured...
Hi all, Cisco prime infrastructure support the forwarding of trap received from wlc to a thirdy party trap receiver ??? From my study on cisco doc this is not supported someone can help me THX
One last CCIE Wireless question. You guys gave good feedback last time. Considering the Meraki acquisition, will it even be worth the ROI? Why order those complicated AP's when you can just replace them with Merakis and manage them through the ISE ...
Hello I have been trying to join a new controller as a anchor to our primary WLC however I am getting Control and Data Path Down. When I run "debug mobility keep-alive enable" on the WLC I see messages stating that it cannot ping the anchor controlle...
Hi All, I have a WLC 2504 with Aps Cisco 1852 and 1832, when I configure a WLAN with security Static Wep it doesn't propagate on the Access Point although it'not disable on the WLC. Any suggest? Any workaround? Greetings Marco
Hello, I´d need to know what is the best Cisco solution nowadays to get a bridge between two offices with 35 meters between them. I'd like to know how to get the max. speed, and what is the recommendation from Cisco. And If It is better a internal...
iPad , iPhone with iOS 11 cannot associate to AP. when i use my ipad and iphone connect to new SSID with authentication OPEN, my devices are disassociate but i use iphone with iOS 10 can connect to SSID normally. anyone here got this problem with...
