Wireless

hello everyone...ive deleted the IOS on my wilress ap1200 ( flash:/c1200-k9w7-mx.122-13.JA4/c1200-k9w7-mx.122-13.JA4). ived tried to upload via tftp but unsuccessful. I cant access through the web brower.when i restart my AP, this is the prompt:ap:iv...

I am trying to route internet traffic locally from the remote site. Can this be done using Flex connect ACL?   Also, If yes, Will i need to define simliar vlans on the remote switch so that the client can route traffic locally?  

When I fixed AP1200 with 100mW (20dBm) and watched ACU in notebook as near as possible between AP and notebook, -10dBm signal strenth is indicated by ACU site survey menu as SNR (80dB) and noise level (-90dBm). I understand -10dBm means 10mW. How can...

would like to know the following.1) what is the default username and password for the ap1200i need the above information when i click on the setup->ethernet (identification).If there is no default. how do i do a password recovery.Thanks

Hi, I will like to know how many users can the AP1200 support? The product specifications did not mention anything on that.

Just wondering if you guys also encounter the issue.   we manage to setup the ME 1851i-K9C. But when it comes to guest ssid. It didnt point to web browser for authentication as per attached image. Anyone have idea on how to point it to web auth. real...

we buy 4 APs,the PID is AIR-AP3802I-H-K9,we use AIR-PWR-50=,and AP3802 can power up,but when we connect ap to switch,we find ap wired0 always down,the status as below:Interface IP-Address Method Status Protocol Speed wired0 unassigned unset down up n...

Hello,   we just purchased and set up a Pair of Cisco Aironet 1532I to be used as Point to Point between two buildings 500 Feet away from each other.   I'm wondering if anyone can share some type of Cheat Sheet that can help us get started.   We have...

I've bought 3 1815w CAPWAP version. Want to upgrade it to mobility express. The main question is - can i make it without air-consadpt?? I can't find it anywhere... And the other 2 questions: 1) should i change firmware for all 3 ap's? 2) there is 2 v...

Hello:We have been using Cisco WLC based wireless architechture for both secure and guest wireless access for over 5 years now. We have about 30 sites globally each site with at least one contoller (larger sites with at least two controllers per site...

Hi Guys,   Need urgent help. does anyone know how to setup the configuration to link the Controller 1851i-K9C to external dhcp?   Really appreciate it. Thanks!