How do I recover the Admin and Guest user account password through the Wireless LAN controller (WLC).if there is any step by step procedure the route me.
Hi, We have 2 WAP4410 (firmware v2.0.4.2), and then we upgrade firmware 1 WAP4410 to v2.0.7.8, somtimes lost connection and the logs looks like this:kernel: ath_bstuck_tasklet: stuck beacon; resetting (bmiss count 28)If the error occurs the ssid will...
When I tried to change my DCA interval parameter. It looks like change successfully. But in fact it is still 10 mins. And I can't change my "DCA Channel Sensitivity" . For the low, medium and high, they are all 5dB. Can you help me check this issue?
Hello Experts,Hope you are doing well! I am using 5508 controller and couple of sites are used on Flexconnect mode, I want to know if I can configure L3 roaming on the SSID? if, yes how? Thanks in advance!
Hello Experts, I have a WLAN setup comprising of 2508 WLC and 1600 series APs. I have WLANs configured in WPA-2 PSK, and could associate all my android & windows clients without any issues. The only IOS device that I have is IPhone 6(IOS and when I ...
Hi Everyone, Via WLC i have configured static ip for the AP.Do i need to config dhcp option 43 on server now? As per my understanding if you configure static IP on the ASA then i do not need dhcp option 43 right?Will client still get the IP address...
HI, I need to add 2 new vlans to the trunk between the WiSM2 and the 6513 chassis. The WiSM is in slot 13 of the chassis and I want to ensure that adding the new Vlans won't disrupt the current connections. Thanks, Waqas
Hello everyone,I have a 5508 configured with multiple network connections using VLAN's and a Cisco 3750.Port 1 -- Multiple SSID's on primary network connect to my nexus core.Port 6 -- SSID 5 -- Internal Wifi ===> 192.168.2.X / 255.255.255.0Port 7 ...
Is their a way to block a device from accessing one SSID and allowing access to another SSID? This is a controller base wireless network. I would like to allow access of a certain device to the corporate network and deny access to the public network....
Hello CSC World!I've got an interesting issue happening in a wireless environment where wireless throughput slows down to a crawl when I set WLAN's to use the management interface on the WLC.When my test network is associated with the management inte...
Hello Cisco WLAN experts, I have attached a file with floor plans that show the 802.11b/g/n heat maps of a customer installationin a high-rise building. All WLAN APs are of same model AIR-LAP1142N-E-K9. To my surprise Prime Infrastructure 1.3 (1.3.0....
Hello all,I am trying to enable the 802.11a and use the 5Ghz band in my house. However, I am having difficulty in doing this. Please see screenshot below. I have select AU (Australia) as my regulatory domain (2nd image). 802.11a band is enabled(3rd i...
i have question regarding the elevation and the azimuth charts found in the antenna datasheets.. The Db loss values are given with higher values near the antennae and the 0dB is shown farther from the antennae.. Shouldn't this be the other way aro...
