Wireless

Hi, We have an SSID running 802.11x. The backend is Cisco ISE authenticating against AD. However, the clients connecting gets a warning about ISEs certificate each time they connect almost. We have replaced the certificates with one signed by Buypass...

Is it possible to install a 1552H with gateway in C1 D2 environment and then run the a cable into through a barrier and into a C1 D1 environment?  If so what barrier will work?

We have 3 3700I APs on a 2500 series controller in Mesh. All the laptops in my organization with Intel WLAN adapters disconnect and are unable to connect (no DHCP IP v4). We have tried the following to no resolution: - Recreate WiFi profile - Winsock...

Hello, I have two new 1702i access points that I need to add to our Wireless LAN Controller.  Are there instructions for doing this?

Hello All, How to enable the telnet for AP CAP2702I from WLC GUI ? and which are all  Access points models aren't allow  remote access?

Hello, I disassembled one of our broken 1702I AP yesterday, for curiosity But then I realized that there are four omni-antennas. But in the data sheet, it says that it is 3x3:2 MIMO internal antenna. http://www.cisco.com/c/en/us/products/collateral/w...

HI,   Just bought the 2 units of AIR-CAP2702E-Z-K9. Now to try to set up as AP1 and AP2 to be seamless connection. So one SSID.   Current situtaion I have 2 units connected (POE ports not AUX or CONSOLE)to gigabit switch and 1 router. Discover mode o...

Release 8.2.131.x (82MR4) The Interim Build process is over, the final 8.2.141.0 code is now posted in CCO Thanks for your interest! . 8.2.131.56 CSCva20321 Radio go stop-on-failure and the LAP cannot re-join to WLC for a while CSCvb18339 DTLS connec...

Seeing if anyone has heard of this issue before. Dell PC running Windows 7 and with a Dual band AC7260 Intel nic is intermittently dropping off the network. The end user try's rejoining the Wlan and is unable too until doing a hard reboot. WLC is 850...

Does Cisco WAP561 device support use as a dhcp server