Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The following queries are in respect to AP High availability (not SSO fail over or Controller HA), meaning if one controller fails, the AP will be failing over to the secondary controller which is in a different Geo location. the AP will be in Flex-c...
Hi all, In Cisco Wireless Flexconnection solution, can you tell me the difference between "Web Authentication ACL" and "Web Policy ACL" . Regards, Claudio Rezende
Hi i configure local radius server on ap 1142n, with my anyconnect can't connect with eap-fast. this my config: aaa new-model!aaa group server radius rad_group server name AAP1!aaa authentication login AAP1 group rad_group!dot11 ssid WPAEAP vlan 15 a...
We've launched a wireless network consisting of ISE 2.0 and Cisco WLC 5508 with version of AIR-OS 8.2.100. When the clients want to connect to wireless network the WLC block the client from connecting to the wireless network with below log, when I ch...
Dears, I have logs on my foreign WS-SVC-WISM2-K9: as i understood, users lose internet because of this... 6 Tue Oct 25 15:30:44 2016 AP's Interface:0(802.11b) Operation State Down: Base Radio MAC:cc:d8:c1:3b:ce:a0 Cause=New Discovery Status:NA 7 Tue ...
Dears, I have on Cisco WC 2504 with 7 APs , I have an issue , the signal is appear on the end users but always the end users have disconnect to the gateway and internet ( multi-times users have ping request time out for gateway and Internet every day...
Dears; Recently, i have changed LAP (light weight access point) AIR-LAP1131AG mode from local mode to bridge mode now, i am unable to find it on controller & surface led light becomes Blinking red-green-amber please, help me to restore it to local ...
Hi I have one site with the 4G not working on an 897 router.no problems with the other 10 sites. configuration of the interface interface Cellular0 ip address negotiated ip nat outside ip virtual-reassembly in encapsulation slip load-interval 30 dia...
We have some remote bridges, that we need to change the IP address on to a different vlan at present using BVI 1 config below interface Dot11Radio0.100 encapsulation dot1Q 100 native no ip route-cache bridge-group 1!interface FastEthernet0.100 encaps...
I'd like to enable the PTT functionality for my new 8821's but am not finding any good sample configs to get me started. Does anyone have any guides on building the XML files to enable this? CUCM is 11.5, Running 8.0.133.0 on WLAN Controller and ha...
I've been projecting WiFi with Cisco 3700i wireless series in a small office of 320 square meters with thin wall partitions,and up to four workers. I'd like to know the coverage area for one AP in square meter i.e how many APs I need. Anyone could h...
Hello, I've recently updated a few area of my buildings from to the 3802E and 3802P access points with external panel antennas for a high density of users in exhibit halls. I am running auto DCA and TCA and have the clean air enabled so essentially ...
I have a WRP500 and need to check one of the settings. Can anyone tell me how to activate the 'reset password' function, or don't you have one? Thanks. Mary
