Wireless

I recently bought the WAP 371, but experienced frequent disconnects on both 2.4 and 5 GHz channels. After upgrading the firmware to 1.3.0.3 the disconnects are gone but the throughput is very low when browsing the internet. Downloading seems fast how...

Hi, I have upgraded my WLC to v8.0.133.0 from 7.4.140.0 and I now cannot get Flexconnect clients to work.  The authentication is passed across to an ISE server (1.2) and I can see that the client is successfully authenticated. DHCP server is central ...

Now I have a 1832 wireless AP, the current wireless network’s working is normal, but can not access the web interface, I would like to reset the factory settings from the external.who can tell me how to do ?

Dear Team, We have Cisco 5508 Controller and Cisco CAP-1252 with Following software version: Cisco Controller 5508 Software Version: 7.4.121.0 Cisco 1252 Software Version:  c1250-k9w8-tar.152-2.JB3 As per Compatibility matrix, Software version presen...

Hi, I am currently using 1252A / G for testing.  When I log into the AP, it allows me to select specific MSC type, Channel, Bandwidth, output power in the web gui. I am looking to upgrade to 3802e with wave2 capability.  There seems to be a new GUI c...

Hello, Today I have two WLC 5508 (with license for 100 AP each of them), on a single site. The WLC are operating in high availability (active-standby). However we have a new scenario, with 02 sites: A and B (attachment). I would like to know if it is...

Hello, Would I like to know, if when I Rehost a license from a WLC to another, I I lose a license amount. For example, I have a WLC with a license of 250 APs. When I Rehost that license to another WLC, Is the license reduced to 200 APs? tks...

I have a fleet of Cisco 2702 access points running on a WLC, and lately I have noticed that the AP's are replying to ARP requests on their ethernet interface. For example, a DHCP request occurs by a wired device which is on a VLAN also trunked to the...

I am doing an audit on 4 controllers and found that on one of them the RF group update time interval is 300 seconds, which is half of the default.  I am trying to figure out how and why this is the case and what it matters.

Hi there,I setup a guest WLAN in our LAB environment. I have one internal WLC connection to an anchor controller in our DMZ. I'm using the WLC integrated web-auth portal which works fine. To gain more flexibility regarding guest account provisioning ...

Hello, We have an issue that we could use some help with. We have 5 workstations in a production environment. because the workstations consist of several network-connected devices, we deploy access points as work group bridges. So, the Wireless clien...

Hi all, I'm just putting this here in case it happens to anyone else as it currently isn't registered as a bug against code 8.0.140.0 and is causing me a bit of grief. I upgraded an 8510 WLC hosting around 600 APs in FlexConnect local auth/local swit...

Are there any gotchas or issues that should be known if you are going to use Meraki's switches to provide POE to Cisco 3700i access points? I know the Meraki will be managed in the cloud and the Cisco access points will be managed by the on premise W...

Hello! I have (2) Cisco Mobility express 1850 Need to create (1) employee WLAN (2) Guest WLAN Have the employee get DHCP from DHCP Server and Guest get their IPs from the Access DHCP while separating the traffic. I have a WatchGuard firewall and a Ci...