Wireless

Hi Trying to setup Snom M700 on CUCM 9.1. getting rejected status. using standard third party configuration along with end user account as any normal setup. is there a configuration  guide I could follow to find out where its failing ?

I have configured two AIR-CT5520 Wireless Lan Controller in high availability with software version 8.1.131.0 I have configured Prime Version 3.0 too. There are 240 AP's model AIR-CAP3702I-E-K9 registered in controllers. For unknown reason the interf...

I'm looking for the right antenna to order for cisco 1552H.  I'm getting conflicting info on cisco website between: AIR-ANT2547V-N (dualband, omni 4/7dBi) versus AIR-ANT2547V-N-HZ  Are they the same omni pole-type antenna? or the -HZ actual panel-typ...

By 2019, there will be 1.5 mobile connections per person globally. Learn more about the Cisco Cloud and Mobile Network Traffic Forecast.How many mobile connections do you currently have?

Hi.I have a script made in Postman for Chrome that I plan to use for making guest users.In ISE v1.3 it worked fine, but not in v2.0I have made changes to the script according to the new versjon of the API, but it still does not work.The script looks ...

Hello forum,   I hope someone can help me with my situation. Let me start by saying I am a total beginner when it comes to configuring Cisco Access Points / Routers. So please in advance pardon my ignorance for some of my entries.  So I am going to t...

Howdy, We upgraded to 8.0.132.0 this week and noticed that on the dashboard we have a count of Active Rogue APs listed, but when we click the link to show us the details that none are listed.  There is no filter in place. Is this a known issue with t...

We are planning to install WiFi in a theater. It is about 6-7 meters to the ceiling and about 500 seats. We are considering six AP 2802E with external antennas mounted in the ceiling, facing down and a few degrees to the back of the theater. Three an...

Hola a todos, tengo un problema con un WAP300N configurado como wireless range extender el cual lo conecto de manera inhalambrica a un  router E4200, una vez configurado funciona a la perfeccion, pero si el router se apaga (fallas electricas) o si se...

Hi,I have two 4500x in VSS, in the first Cat4500x there is the WLC Primary and in the second Cat4500x there is the WLC-HA.Both WLC must be on the same etherchannel or can be in a different ethernchannel?Regards..Mirko Severi.