Wireless

I am experiencing the problem listed below only with IOS devices when the WLC interface is routed through a firewall. If traffic is bypassed the firewall the IOS device connects instantly. I have tried testing with Fortigate, pfSense, and untangle fi...

I am applying an ACL on the controller, and permitting only myself and the other Admin access to the Controller GUI and denying everyone else. However, when we have someone put the IP in the URL, they are still able to see the LAN Controller GUI. Wha...

Hi, in my environment i've a virtual wireless lan controller version 7.5.102 running on VMWare infrascture. All APs are configured in Flex Connect mode, grouped in 2 differnt groups to broadcast a total of 3 WLAN. I'd like to setup a new guest wlan f...

Hello everyone,  I'm currently in the process of deploying IPv6 on our wireless infrastructure and I was wondering if someone share some of the experiences. Our topogy is fairly simple, however, I've seen that there is some issues with mobility suppo...

Hello everybody, I have the following problem with W10 and W8.1 notebooks: when the PC is powered UP and the user logon I have all my network shares not connected. I think it could be a problem of NIC driver delay in loading. Anyone has the same prob...

Hi all, I have a cisco 887vag with 2 interfaces: 1- WAN interface that give VPN 2- 3G cellular interface sim card When I configure the Cellular 0 encapsulation to SLIP and the Dialer 0 encapsulation to PPP and enable ip cef, I have pings to some addr...

Hello, I plan to local switching 2 SSID by mapping to two local VLAN Data SSID = WLAN_A Device SSID = WLAN_B Data VLAN = 10 Device VLAN = 20 But I don't plan to introduce new native VLAN for AP Management, will it work if I just use Data VLAN set as ...

We've got a wireless network set up already and we're getting a Cisco ISE for this project. We're investigating deploying two factor authentication, with the two factors being: Domain Username/Password and a Certificate.    Is the only way to do two ...

WLC: 8.2.10 (5520 in HA) PI: 3.0.2 AP: 3702i (with Halo) PI can see the WLC with the community strings but can not see the single AP that is currently registered?  Licenses are applied to the WLC and to PI. Thoughts?

I have a virtual WLC running software version 7.6.130.0.  I have a variety of APs on it from 1141 all the way to 2702's.  I have 104 APs current connected with 7 licenses remaining. I just purchased 2 refurbished 1602i's and am trying to get them to ...

Hello, do the indoor APs 2700 and 3700 in autonomous mode can work as wireless bridges? In the datasheets I cannot find such information. These models have 4 ports for external antennas, but using only one such as AIR-ANT2465P-R or AIR-ANT2485P-R won...

I have 5 7925G wifi IP phones in a sandbox environment.  They are able to reach and register with the 2921 running CME 8.6.  After they registered the first time using network profile #2, access to the menu items was disabled.  When I moved them to n...