Wireless

In the given Cisco Packet Tracer network cannot ping from 193.0.x.x to 192.168.0.2( any network on the other side of the router) but opposite is possible.

we are having 13 WLAN and having  one default AP group.If am adding one more AP group pass only few SSID ,will it improve the signal strength, any other performance ,reduce the load on the access points.

Hello,i Have 2702 access point not joining to 5508 controller. both access point and controller are on different VLAN.Im using code 7.6.130.0 on controller.I configured DHCP server based on below link using option 43 for APc2700.http://www.cisco.com/...

Hi there,A couple of WLCs have been installed in one plant I am supporting and now guest users cannot connect to the hidden wireless network "visitor".I found the users were not applied with these new WLCs. I applied them but still the problem persis...

Can anyone confirm, if we have HREAP support on WLC CT5760, if yes, is their any design guide, if doesn't support, any alternate solution to get HREAP connectivity with AP's located at a different site and WLC at datacenter and having local switching...

Hi all, Recently, I was implementing a project in the hospital.The  general enviroment is that one Core SW connected with  three Distribution SWs, running ospf between all（The three Distribution SWs are used for  3 different departments so they need ...

Hi, We got many 2602 AP running under Controller mode. Every night Cisco Energywise turn the power off to these AP's and next morning turn it back on. But randomly in a month few AP fails to come back. When I check on console I see error - The system...

Hi, I know Mobility Work Center(MWC) could be used to configure Mobility Domains, SPGs, etc., and deploy them onto controllers.. but i am wondering how does it work in the following scenarios.. a) The devices discovered already have Mobility configur...

Deployed new WLC 2504 and when clients connect for the first time they take for ever to get an IPv4 address. On the controller the connected client has an IPv6 address initially for a while, then it finally flips over to IPv4. Is there a setting I'm ...

I have 3 5508 controllers on 7.0 software which supports older aps i.e. 1231 ... For new expansion we have purchased 3602's which only run on 7.2 or higher. I have a 4th controller that is on 7.4 ... can I connect the new 3600's just to that controll...

what is the exact procedure when restarting two CPI appliances configured in HA?should the HA be removed first?should the second appliance be 'ncs stop'ped first, followed by the primary ? 

I have two WAP4410N access points set up for B/G/N intermittently I will not be able to connect with iPhones or iPads. It seems I have to reboot all devices all the way back to router to fix. Sometimes that does not even work and I have to repeat sev...

Hi All, As we know, an AP stores its last known WLC's in its NVRAM.  Is there anyway to remove controllers from that list? i know there is a CLI command to specify a controller - capwap ap controller ip address x.x.x.x - so i am hoping there is an al...