Wireless

Hi,after an RMA i installed a new WLC 5508.Now i want to pair the new controller with the old one to the HA mode.The Controllers are in SSO mode.IP Adressing of both controllers are ok but the Mobility MAC Adress on the new Controller is not right an...

hi,I have several controllers with different configuration, the problem is that sometimes APs registers with other than primary or secondary specified controller and changes their configuration, how can I restric APs to register only with their prima...

                   Hi guys,I have deployed AIR AP1142 model access points in various locations and some of them get their Radio0 going down intermittenly and the only way is to do a reload. The log just shows that the radio0 went down.Any friends out...

When deploying the 2702 and 571 APs, what is the suggested distance between them for maximum coverage? 

We are trying to test a new feature in Cisco's new controller code 8.0.110.0.Per Cisco's documentation, the feature can be enabled so that one WLAN (SSID) allows both FT clients and 802.1x (non-FT) clients.We have tested multiple clients with this fe...

Hi there,Is it possibe to use sleeping clients when using ISE and CWA?I was thinking of enabling layer3 auth with web auth on mac auth failure, but will that work with CWA?Or is the only solution to use LWA?

is ISE a must if i need my WLC (5508) to send guest passwords to sms gateway?  (can we integrate wlc directly to sms gateway)? 

Hi, We have WLC in version 7.4.121 and 1131 AP in flexconnect.We want to apply Qos and i use "Override Per-SSID Bandwidth Contracts", Downstream and UpStream, but this had no effect.The WLAN is open without Layer 2 Security.Have you an idea ?Thank.  

Hi, I have 2 wlc runing in SSO HA mode. I want to migrate the second WLC to N+1 mode, Do i need to purchase 50 ap count license to the secondary WLC to support ap while configuring N+1 mode. My model is Cisco 5508Regards,JJubair.S

Hello, I have four WAP121 and one WAP321 and I want them to be working in WDS mode to cover a small building. I want to have authorization via Captive portal (only supported on WAP321 as far as I remember). Would it be possible to authorize once bein...

Hi Experts, In my project I have another WLC 5508 and I need to make it as redundancy between two 6509E chassis. How can I do that? Thanks for every one. Mohammad Saeed

HiI followed same steps in URL to install NPS with RADIUS in microsoft but i am stuck in step 15"Select Microsoft: Protected EAP (PEAP), and click Edit. Ensure the previously created domain controller certificate is selected in the Certificate issued...

Hi everyone,We have a 3-year-old MSE 3310 that is EOL and apparently useless to us now that our WLC is on software version 7.6. We're preparing to get rid of it and need to set it to factory defaults. The problem is, even before the WLC upgrade, the ...