Wireless

 HelloI am trying to upgrade an AP with the following details from an Autonomous AP to Lightweight AP remotely via CLI as that is the only way I have access to the device.sh invNAME: "AP1130", DESCR: "Cisco Aironet 1130 Series (IEEE 802.11a/g) Access...

Scenario:1 virtual wireless controller50 access points, some of them some local to the controller (same site), other on remote sites, all in flexconnect mode.Is there a way for a wlan to be locally switched for a group of ap's, essentialy those local...

Does anyork for my Cisco IP 7900 series telephone.  I have been loork for my phone prefereably a cordless headset.  I would like either a Plantronics or a GN Netcom / Jabra,  I have been looking at the new Plantronics CS540 wireless headset but not s...

I have two AIR-SAP1602E-A-K9 that have AIR-ANT2544V4M-R= Antennas attached.  3 of the 4 ports are attached as the AP only has 3 ports.  They are both running off PoE from a D-Link DGS-1210-10P switch.  The AP reports it has full power.The signal stre...

Hi, Just a quick question...If the software version on an access point is newer than that on the controller, will the controller be able to see / connect to the access point?

interface Embedded-Service-Engine0/0no ip addressshutdown  How do i remove the above config from my default 2901 configs? any hint??

I have one WLC 5508, i set Interface management on port 1 and we have 3 port remaining on controller to use. I try to connect from Management interface to switch but it is not have any connection to switch. I only connect from AP to Interface. i woul...

Hi AllWe have WLC2504 (  Upgraded to Firmware 7.4) and AP'S are AP 1602When Wirless Controller trying to Connects AP'S then they are hanging and same is happening for AP'S os we are not able to do configuration.Pinging continous is breaking for WLC I...

I am deploying a SPA3102 that is forwarding PSTN calls from an analog  PBX to the IP address of a WiFi Handset. There is no server and no  registration in this configuration, just IP dialing.Can you give me  directions.

Hi I have WLC 2504 version 7.4.100 and I need to set up AP policies with MAC and SSCHow can set UP SSC certificateI enabled SSCBut in the controller I see this message : SSC device certificate not present(Cisco Controller) >show certificate sscSSC Ha...

Hi all, I am facining an issue with 7925 ip phones. My enviroment has a WLC 5508 , Lightweight 1041 and 1602 access points. The problem is that the ip phones occasionally flap wireless is connection.The signal comes and goes rapidly and it may take 1...

Hi,I am trying to configure the Access Point module on my Cisco Router (897AVW), however I am unable to route / ping between the router and the AP.In a few examples I've seen, the wlan-GigabitEthernet interface has the command:switchport trunk allowe...

Hi i have a cisco 3850 at a branch site and would like to know if i could use its WLC to join to our mobility group at our Main site instead of having it as a standalone WLC Thanks

Hi, we use a 5508 (7.3.112.0) and 3502i APs. We are having an issue where multiple clients connecting to a single AP(Like in a training room) are being disconnected or generally having a poor user experience. I have attached a debug of a failed sessi...