Wireless

hi,we have 4 WLC Wism controllers with 4 wireless wlan and 4 wired guests vlan.We are used to do daily reports of client sessions for log pourpouses and everythig works well for wireless clients.We cannot do reports for wired guests, even if we selec...

HiI want buy an Access point which cover 300 Meter coverage Area.Have any data sheet or link where I can found which AP coverage how many Area, Like 1042 Access Point cover how many Feet Space.Please Help.RegardsIqbal

hi,I am using WLC 4404 and wireless is configured....I dont have much knowledge of RF.. so anyone can help me with this?There are two options in wireless tab, 802.11a/n and 802.11b/g/n.In 802.11a/n--> DCA, channels are configured as 36, 40, 44, 48, 5...

hi,we have 4 WLC Wism controllers with 4 wireless wlan and 4 wired guests vlan.We are used to do daily reports of client sessions for log pourpouses and everythig works well for wireless clients.We cannot do reports for wired guests, even if we selec...

Hello!I have some trouble with the setup of an oeap 600 ap. The ap has joined the controller as it should and the remote-lan connection to my corporate network works well, but i can't connect to the corporate wlan.When i check the event log on the ap...

Does anyone have the IOS image for the Aironet 1310? May I have a copy of it please. I cant access to Cisco support today. - C1310-k9w7-tar.124-25d.JA1.tar - C1310-k9w7-tar.124-21a.JY.tarThank you very much.

this note is from the 5508 controller config manual, does this apply to 1040 access points in a mesh network?Note:The recommended power source for MAPs is either a power supply or power injector. PoE is not a recommended power source for MAPs.

What is propoer sequece lightweight access point association with WLAN controller ???Did i do correct ? Please, see attached file !!!

I am managing wireless network in a convention centre which has almost 2000 APs and 28 WLCs. RF ID and location tracking enabled. In WLC I can see 500+ rogues getting detected in each WLC in different mac address. Few of these mac I can trnasilate in...

i have a WLC (5508) - trying to enable AP group vlans based on instructions from:http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008073c723.shtmlhowever, my problem is that i don't have the 'ap group vlans feature ...

Hello Could somebody explain to me how an AP 3500 get to be registered in a controller 5508??, so, i have seen a lot of information of wireles deployment guide but i haven't understood yet how the process or flow is for getting the AP to be registere...

Hi, Is it possible to locally switch the guest SSID with the WLC at the central office as the DHCP server along with web authentication?. If yes, please let me know how. Thank you, Jino