Wireless

Laptop wifi connection(WAP321) Works! for the file server and internet services.However printing to specific printer(wired connected) on the network is failing. Unable to connect.Is there a 'port' configuation that I might have overlooked for the WAP...

Hi, I got a modem DPC 3925 and I saw that the modem emits a sound as a mosquito after three or four hours turn on. I turned off the equipment from energy oftentimes, but the sound restart after three or four hours turn on. I don't know if this is a n...

Hi!I´m about to upgrade a customers appliance box to PI 1.3. Have anyone done it? and were there any issues with license?I guessing an upgrade to 1.2 would be almost the same, license wise. If anyone has input fram that it would also be appreciated.A...

A customer uses autonomous wireless AP's for some smaller site's.Usely this is no problem, yesterday i installed a new site with Cisco AP2602's running:Cisco IOS Software, C3600 Software (AP3G2-K9W7-M), Version 15.2(2)JA, RELEASE SOFTWARE (fc1)Techni...

Hi!At a customers site we (I) setup a "WLAN-bridge"as a backup-link/redundancy för a fiber-connection between the main office and the wharehouse, a distance of approximately 500 meters.The bridge consists of two AP1240BG and external panel antennas a...

For some but not all of our WLCs, our WCS is not able to View RX neighbors for selected Radio in the maps.WLC is running 4.1.171-code, WCS is using 4.1.83 Base+Location.I use Monitor-Maps, slecet a map and hover with my mouse over one of the APs to s...

                   Hi All,                              We have been having issues with our AP's after wide spread power outages. The AP's will associate with the controller but will not with its RX neighbors. We then go ahead and reboot the AP and t...

Hi thereI would like to redirect web traffic from WLANs on a Wireless LAN Controller 2500 to a proxy server in a remote site. I'm using ironport proxy server and Cisco 3560 Layer 3 switch. Basically current scenario is:Wireless Guest Users get authen...

We have some Cisco aironet 1524 AP's. Can I connect these AP's to a 21 dBi Sector Antenna and use it for Wi-Fi Broadcasting. Maybe even for indoor penetration for a distance of 150 to 200 meters?

Hello All,I am getting the below error when AP 3502i with the code 7.4 tries to register with the VWLC 7.4.100.60...?DTLS-3-HANDSHAKE_FAILURE: openssl_dtls.c:681 Failed to complete DTLS handshake with peer X.X.X.XAny Quick help would be appreciated.....