Hello, guys! Need your assistance in configuring QoS on a wired network for the ability to watch IPTV on wireless clients' devices with a good quality.What we have: WLC5508------ trunk ------3750------ trunk ------2960------access------AP1140...
helloi'm planning to replace a wism1 with a wism2. i've had a look at the deployment guide:http://www.cisco.com/en/US/products/hw/modules/ps2706/products_tech_note09186a0080b7c904.shtmlit states as a feature for wism2 - "Interoperability with other s...
Hello all. I am new to the forum and have just enough networking skills to be dangerous. A+ and Net+ Certs in 2000. Self taught on my AP's and I am now finally to the point that I need help. Bare with me.I have 2 Cisco 1200 G AP's connecting 2 dif...
Hi:Somebody help me, l have an wireless infraestructure that use WPA2 as a network authentication but some weeks ago it was installed a new mcaffe software on my laptop called HIP ( host intrusion prevention). since this software is installed on the ...
Hi everyone,Let's say I have a 100m cable running from a standard switch to a power injector (namely AIR-PWRINJ4). Do I have another 100m from the injector to the access point ?Thanks in advanced.Andre
We are deploying 3600 AP's with a 2504 and would like to create multiple SSID's that are mapped to unique VLANs so we can control the traffic at the Firewall. We have the 2504 up and running with AP's but there appears to be no where in the 2504 con...
Looking for some experienced feedback, as we are upgrading soon and are considering altering a detail her or there when we do so.In a mixed environment, at what ratio of CCX-supporting clients to non-CCX-supporting clients should one consider switchi...
Hi!I have a WLC CT-5508 and 25 AIR-LAP1040. The customer wants the access point gives two wifis, one private for voip, and one public for "public" access. And every wifi on a different vlan, if possible.The questions are:How to assign the ip directio...
Hi I have a 2951 trying to configure 3G, upto now i think i have loaded the basic configuration but I can't ping the internet address. I have attached my router configuration as well as the debug ppp negotiation.My 3g SP said there's no password enab...
Is anyone running Wireless QoS using 5508's? I have been reading lots of info, but still struggle with some of this. I have not dealt with QoS much on a wired network and never on a wireless network. I know there has to be a shared comfiguration betw...
HiI am trying to configure a AIR-CAP3602E-E-K9, but i am not really able to do much via the CLI.The only configuration examples shows that you need a wireless controller, but i dont have one, and i only have 2 AP's so i would be oaky with standalone ...
Hi,I have setup a global solution with 174 APs spilt over 4 Regional WLCs and all is working properly but I need to double check some configuraiton like if each AP has the correct high avalibility setup. I can do that over the GUI but I woul like to ...
Hello all-We are deploying two 5508 WLC running 7.2 ios. Is it possible to anchor these to a 4402 running 7.0.116.0. Is there any version mismatch issues. We can find documents on the older compatibility but not on the new code. Thanks
I have 7 standlone access points, is it right that i need to use on of this ap like central server, is it right?also if i dont have dhcp server, can i use this central ap like dhcp server?thank you
