Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Hi All, We have a small issue while creating guest account through WCS. Since the WCS is located in a different region than that of the controller, while creating guest accounts, the WCS considers the local server time and not the time on the WLC. I ...
My network has 2 AIR-WLC2112-K9 controllers and many AIR-LAP1131AG-A-K9 .There is a Adhoc Rogue AP detected that I would like to remove of my network.I do not know where it is.Which feature should I use ?Thanks.Rosa
With Tejas Shah Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions from Cisco expert Tejas Shah on One Management with Prime Infrastructure 1.2 Combining the wireless functionality of...
Hello, I´m wondering if it`s possible to export the defualt web auth portal(web login page) via tftp to a computer from the Cisco WLC 5508 and then modify it and then import that customized portal to the WLC 5508?Best RegardsMike
I have two WLCs (5508 - v7.0.220 and 2106 - v7.0.116) that were NMSP connected to a MSE (v7.0.201.204) according to WCS (7.0.172.0)The MSE reloaded(Actually a reload command from WCS hung the MSE and it hard to be hard rebooted) and I ran into a NTP ...
We have one SSID using web-auth with ISE.On WLC we configured idle timeout fot 2400 seconds and on wlan>advanced with 65535 seconds for session timeout. But we are having continuos deauthentication in about 10 minutes.When we check WLC, our mac-ad...
I have received many conflicting answers to this question. I'm hoping to get a decisive answer here.Can 2 Aironet 1042's using WDS handoff a session between them without any other network hardware needed?Thanks,Pat
I upgraded our WCS over the weekend to the new 7.0.172.0 release. Daily now I am getting one or two "ap impersonation" alerts which I wasn't before. These are coming from existing clients that have been on the network for quite some time.Has anyone...
Im using 1131AG AP.Locally switched WLAN don't have problem.Authentication used: open/wpa-psk/wpa2-pskPinging the IP Address of the vWLC dynamic interface (WLAN-SSID Mapping) is ok, but with the gateway failed.Any ideas how to solve this?
HiTrying to use ise (1.1) as an external webauth within a flexconnect/h-reap setup (WLC:7.2.103)... Can't get it to work.. After a lot of testing/troubleshooting found this: http://www.cisco.com/en/US/products/ps10315/products_tech_note09186a00807361...
WISM v7.0 VLAN Select.Anyone can confirm if the VLANs subnet to be configured under interface group MUST be having the same subnet.Eg. VLAN1 - mask 255.255.255.248 VLAN2 - mask 255.255.255.120Would these two VLANs be able to work together in int...
Hi,I want to test ncs 1.0 virtual appliance demo version with vm, as we are not having the hardware to install vmware Vsphere hypervisor we tried to mount in vmware workstation.Vmware workstation support to mount the virtual appliance with ovf or ova...
I noticed that the radios are admin down with this IOS. I can't seem to find where on the 2006 controller to enable the radios? Can someone point that out to me. Thanks!
Resolved! Disable 802.11a
HiWe are having 5508 controller with Lightweight access points 1142, IS it possible to disable 802.11a on certain access points before turning it off completely on the controllers?? Could you provide steps for doing so on WCS?Thanks Krithika
Greetings,This question has been asked in various ways in the past, but I feel never answered adequately.My Scenario;My customer has multiple sites, each with a 2504 WLC.A data center with a 5508 in the DMZ acting as Anchor for the remote sites.ACS 5...
