Wireless

We have a pair of Cisco Flex 7500 Series Wireless Controllers in our DCs. We installed a new site with a number of APs. Each AP has a few SSIDs with various VLANs associated. The install went fine and the site has been working. Overnight there was a ...

Hi All, How many concurrent management connections PI 1.3 support? Thanks in advance for any replies.

   Can someone tell me how to increase the client session history?  It seems to only give me 32 days worth of history.  I would like at least 6 months of history.  TIA

Maybe a silly question, but when AP fallback is configured, when does an AP decide to fallback to its primary controller ?When this controller responds to a ping ?When the controller has an active mobility group connection ?I want to prevent 300 APs ...

Is there any way of connecting to a WiFi running at channel 13 ? I mean is there any possibility of adjusting my wifi adapter tuned to channel 13?---Posted by WebUser Vikas Mishra from Cisco Support Community App

Hello,Does anybody know how many concurrent client connections the 1602E access point can handle.Thanks.

Hi i need visio stencils of wireless lan controller for making hld(symbols)

what is the difference or purpose of the CME # LOAD command and the #create cnf-files? They both seem to create config files for the phone to download.

With Shankar Ramanathan   Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about how to monitor, troubleshoot, and configure voice over WLAN on Cisco Unified Wireless Network and 79...

Hello,I have WLC 5508 in software version 7.2.111.3 and I would like to know, if there is possibility to configure accounting update interval for stop time. Because I have problem with obtaining stop time in accurate time, I received it with delay in...

                   Hi,you might have seen this several times,but please take a minute to read.My phone is stuck in recovery mode.I connect it to usb, the computer asks me for drivers.I found the good page on the website to download it, but it require...

I have tried to figure out how to do things in PI 1.3 with the Lifecycle Theme, but I cannot figure it out. The configuration guide is written for the Classic Theme. Where can I find documentation for the Lifecycle Theme?

Does ISE support IPv6 in its dynamic ACLs? We are a dual stack IPv6 site at present. We could leave the guest LAN on an IPv4 only site for the moment, but we intend to go forward and support IPv6 fully. If we wanted to apply DACLs to a port that had ...

Hi, I'm working on a solution to Implement WLC HA v7.5 and have been reading the WLC Config guide v7.5 but looking at the sections within the respetive chapters relating to LAG Config restrictions and HA Config restrictions, I'm not entirely sure tha...