Wireless

Hi,In our factory's mesh network, there are temperature/air sensing sensors connected to mesh network. Now in one of the corner locations, there is an mesh ap. a new similar sensor is to be installed near this mesh ap point for sensing that area. But...

I am trying to install a AIR-BR1310G wireless link between two buildings. I configured the setup in a lab and had everything functioning. Shipped it to the client who is now trying to install it. The radio link is up, but we are having issues with...

Newly installing a Cisco AP541n.  Can I use the same power over ethernet adapter as I've used for the Cisco 1100?                  

HiNeed some help. I have setup guest access on the controller and this is not working at the moment.DHCP server setup on the controller for the Guest users.You are able to connect (get ip address from controller) and the browser gets redirected to 1....

I have multiple 1142 and 1252 access points on a 5508 controller.  I only allow Internet access to devices/users that have authenticated to Active Directory.  I'm seeing lots of traffic from my access points trying to access http://mus.cisco.com.  Wh...

All,I have fat fingered an ACL on my VTY for an Autonomous 1240AG AP. So I am unable to SSH/telnet into the AP. I can however still HTTP into it. Is there a way to remove the VTY ACL from the web interface? or do I have to rest it?Thanks for your hel...

  Hi,I am planning to have FAT access point 1242 connected to AIR-ANT2506 external Antenna.Are these two things compatible?Secondly, AP and Antenna will be 230 feet away, hence I am planning to buy a cable from Cisco (Part Code AIR-CAB050LL-R)Is this...

I am upgrading from 7.0.98 to 7.0.116I have downloaded the code to the controller.  I  predownloaded the code to the access points.  I did a image swap, but  the AP's still show 7.0.98 as primary and now the backup image as well, with 7.0.116 as  the...

hi, I have recently setup one stand alone aironet 1140 with mostly default settings with WPA key. but, it seems sometimes it's dropping the connections. hardly 15 users are connecting to aironet at the moment. any ideas would be appreciated. thanks

Hi got little confuse that 1142N-E0K9 will support both 2.4 and 5 ghz or only 2.4 .                  

I have a 1552 E-A-K9 AP, connected  to a 5508 WLC,Software Version                 7.0.116.0. The problem i  am experiencing is that all the existing P's on the WLC is working  100%, ( 1142's) but.The  1552 does lease an IP adress from DHCP, and it d...

                  can i export NCS's database to another database?

                   can i export NCS's database to another database?

My customer has a problem with the memory in his WLC. The process Dot1x_NW_MsgTask_0 is occupying 83% of the memory. This percentage does not lower. What can be?Rds,Emilio Ramos