Wireless

Anyone know the structure of a page on java, cause i have a problem to download the .tar is this correct on the structure???

I've found some discussion on this, but nothing that's helped resolve so I'm hoping someone can help. We recently purchased a 2112 WLC, running version 6.0.199.4. I have everything running through a single port on the controller, which is connected t...

Hi everyone,I am trying to get my Cisco AP's to send the SSID or some kind of identifier of the SSID in the radius request attributes.This is needed for user realm mapping on my radius server.Any ideas on how this could be achieved?Nicolai

Greetings again all! I have what I fear is a fairly basic question regarding the switchports on the rear of the 2106 controller. How do I configure them for use? I'm using port 1 as my uplink to a trunk port on an ASA and my network traffic to the ma...

Hi,I just need to know that is WCS capable of creating guest account in a way that the starting time line can be triggered after first loginThanks

Hi, we have purchased one NCS PRIME-NCS-APL-K9 appliance. We are looking at connecting this box to two more swicthes configured in HSRP for the VLAN on which this box will be place. Can i configure active/stand-by teaming of both the ethernet ports a...

Hi i have a new Requrnment . Customer has 15 diffrent sites and one central site . They want to keep WLC in central site . And access ponits will be there in diffrent sites . The sites are connected via MPLS .They want Diffrent SSID in each site with...

Hello,Here is part of router configuration of dhcp for Wireless AP.Ip dhcp excluded-address 172.16.100.1 172.16.100.100ip dhcp pool lwapp-apnetwork 172.16.100.0 255.255.255.0default router 172.16.100.1option 43 ascii "172.16.1.10"ip dhcp pool client-...

Hello,I read some where that I can pre-position (upload) the new LWAPP or CAPWAP to access points before I upgrade the WLC code. This will reduce the time it takes for the APs to download and run the new code from the WLCI am not able to find a docum...

I recently purchased the E3000 and need a little help. I thought i had read that this devices can act as an access point. There is no clear "access point" mode option so i configured it as best as i could to work with our radius server. I can connect...

Hello there.I'm about to set up a wireless environment and my question is: can I define 1 Root AP and somehow "sequentially" mash APs, each of these a bit farther away? Like this:Root AP0 --> Mash AP1 --> Mash AP2 (which connects to AP1, because not ...

hiI have 5 access points and want to configure channel and its frequencies...what should be the channel frequency and its operating mode so that user would get bestpossible results??I am facing some wifi fluctuation problemsI have set frequency chann...